Abstract:An onset condition of gas entrainment (GE) due to free surface vortex has been studied to establish a design of fast breeder reactor with higher coolant velocity than conventional designs, because the GE might cause the reactor operation instability and therefore should be avoided. The onset condition of the GE has been investigated experimentally and theoretically, however, dependency of the vortex type GE on local geometry configuration of each experimental system and local velocity distribution has prevented researchers from formulating the universal onset condition of the vortex type GE. A real scale test is considered as an accurate method to evaluate the occurrence of the vortex type GE, but the real scale test is generally expensive and not useful in the design study of large and complicated FBR systems, because frequent displacement of inner equipments accompanied by the design change is difficult in the real scale test. Numerical simulation seems to be promising method as an alternative to the real scale test. In this research, to evaluate the applicability of the numerical simulation to the design work, numerical simulations were conducted on the basic experimental system of the vortex type GE. This basic experiment consisted of rectangular flow channel and two important equipments for vortex type GE in the channel, i.e. vortex generation and suction equipments. Generated vortex grew rapidly interacting with the suction flow and the grown vortex formed a free surface dent (gas core). When the tip of the gas core or the bubbles detached from the tip of the gas core reached the suction mouth, the gas was entrained to the suction tube. The results of numerical simulation under the experimental conditions were compared to the experiment in terms of velocity distributions and free surface shape. As a result, the numerical simulation showed qualitatively good agreement with experimental data. The numerical simulation results were similar to the experimental results in terms of the shape of free surface dent and the velocity distribution around the vortex, although the GE itself was not completely reproduced due to a lack of enough mesh partition. After confirming the applicability of the numerical simulation to the GE evaluation, several parameters, such as suction velocity and a configuration around suction mouth, were numerically examined to evaluate their influence on the GE. The tendencies of the GE occurrence enhanced by larger suction velocity or suction mouth on bottom surface enhance occurrence of the GE were obtained from the simulation results. These simulation results implied that the numerical simulation has enough potential to be used for the design work.

THE NUMERICAL SIMULATION RESEARCH OF GAS ENTRAINMENT BASED ON THREE-DIMENSIONAL MODEL

Experimental and Numerical Simulation on Sequential Three Phase Jet-Loop Reactor

Modeling and numerical simulation of gas-solid jet in the transitional-rarefied regime

Numerical Simulation of Two Coalescing Turbulent Forced Plumes in Linearly Stratified Fluids

Numerical Modelling of Bubbling Flow Dynamic Behaviour in a Bubble Column

Numerical Simulation and Experimental Investigation of Flow Field in Gas-Liquid Cylindrical Separator with Baffle Configuration

Three-Dimensional Numerical Simulation of Air Exhausted from Submerged Nozzles

Study on Applicability of Numerical Simulation to Evaluation of Gas Entrainment Due to Free Surface Vortex

Numerical Simulation of Hydrodynamics in Downers Using a CFD–DEM Coupled Approach

Numerical Simulation of Gas-Particle Two-Phase Flow in Impinging Streams Gasifier

Numerical and experimental investigation on droplet entrainment mechanism and closed equations of two-fluid model

NUMERICAL SIMULATION ON DENSE GAS-PARTICLE RISER FLOW

A quasi-three-phase approach for simulating gas-solid fluidized bed under different flow patterns

Numerical Simulation and Experimental Study of Two-Phase Flow in a Vertical Pipe

Studies of gas-liquid two-phase flows in horizontal mini tubes using 3D reconstruction and numerical methods

Development and Validation of a Two-Fluid Three-Field Model for the Vertical Upward Flow

Three-Dimensional Modeling of Gas–Solid Motion in a Slot-Rectangular Spouted Bed with the Parallel Framework of the Computational Fluid Dynamics–Discrete Element Method Coupling Approach

Numerical simulation of gas-liquid two-phase flow in the micro-fracture networks in fractured reservoirs

Discrete element simulation of gas-solids flow behavior in riser

CFD‐DEM Simulation of the Spout–annulus Interaction in a 3D Spouted Bed with a Conical Base

Numerical analyses and experimental verification on multiphase flow measurements using a gamma ray densitometer with blind tee mixing