Abstract:To develop a highly chemically stable polymer electrolyte membrane for application in a direct methanol fuel cell (DMFC), four styrene derivative monomers, m,p-methylstyrene (MeSt), p-tert-butylstyrene (tBuSt), divinylbenzene (DVB) and bis(p,p-vinyl phenyl) ethane (BVPE) were graft copolymerized into poly(ethylene-co-tetrafluoroethylene) (ETFE) films followed by sulfonation and hydrolysis. The latter two monomers were used as crosslinkers. The graft copolymerization was carried out by the γ-ray preirradiation method. The influence of the preirradiation dose and the grafting kinetics were investigated in detail. Sulfonation of the grafted ETFE films was performed in a chlorosulfonic acid solution, by which the sulfonation ratio reached about 90%. By means of the FT-IR and TG–DTA measurements, it was evident that the monomers were grafted into the ETFE films and that the sulfonic acid groups were attached to the aromatic rings of the graft chain. Assessing their potential to serve as polymer electrolyte membrane in a DMFC was performed by measurement of the ion exchange capacity, proton conductivity, water uptake, chemical stability and the methanol permeability. The newly obtained membrane possesses significantly higher chemical stability than the traditional styrene/DVB-grafted membrane and six times lower methanol permeability compared to the Nafion® 112 membrane. Therefore, this study reveals the possibility of the developed inexpensive four monomers-grafted membranes, which could provide an attractive alternative as a substitute for the expensive Nafion® membranes for DMFC applications.

Synthesis, characterization, simulation of 4-styrenesulfonyl chloride and its application in preparation of proton exchange membrane through radiation induced grafting

Bulk Graft Modification of Polyolefin Membranes by Combining Pre-Irradiation-Induced Graft and Supercritical Co2-Swelling Polymerization

Preparation of proton exchange membrane by radiation-induced grafting of PVDF film

Improving the Hydrophilicity of Poly(vinylidene Fluoride) Porous Membranes by Electron Beam Initiated Surface Grafting of AA/SSS Binary Monomers

Sulfonated Polyaryletherketone with Pendant Benzimidazole Groups for Proton Exchange Membranes

Surface modification of PVDF porous membranes by electron irradiation

A novel cross-linked anion exchange membrane with conjugated and non-conjugated pyridine groups

Preparation and characterization of chemically stable polymer electrolyte membranes by radiation-induced graft copolymerization of four monomers into ETFE films

The Microstructure and Character of the PVDF-g-PSSA Membrane Prepared by Solution Grafting

Synthesis of Fluorinated Polymer Electrolyte Membranes by Radiation Grafting and Atom Transfer Radical Polymerization Techniques

Fabrication of Silane-crosslinked Proton Exchange Membranes by Radiation and Evaluation of Fuel Cell Performance

Synthesis and Performance of Acrylonitrile-Styrenesulfonic Acid Copolymer Proton Conducting Membrane

Effect of Sulfonation Conditions on Properties of Ion-Conducting Membranes Based on Polystyrene Grafted on Gamma-Irradiated Polyvinylidene Fluoride Films

Synthesis and Characterization of Poly(Vinylidene Fluoride)-G-Sulfonated Polystyrene Graft Copolymers for Proton Exchange Membrane

Quantitative analysis of proton exchange membrane prepared by radiation-induced grafting on ultra-thin FEP film

Design of Polyphosphazene-Based Graft Copolystyrenes with Alkylsulfonate Branch Chains for Proton Exchange Membranes

Study on the mechanism of graft polymerization and sulfonation of proton exchange membranes for fuel cell

Hydrocarbon proton-conductive membranes prepared by radiation-grafting of styrenesulfonate onto aromatic polyamide films

RADIATION GRAFTING OF STYRENE/MALEIC ANHYDRIDE OR STYRENE/DIMETHYLAMINO ETHYL METHACRYLATE BINARY SYSTEMS ONTO POLYTETRAFLUOROETHYLENE POROUS MEMBRANES

Orgn 674-Synthesis And Characterization Of Sulfonated Poly(Arylene Ether Sulfone) Copolymers For Proton Exchange Membranes

In-situ synthesis of cross-linked imidazolium functionalized Poly(styrene-b-isobutylene-b-styrene) for anion exchange membranes