Abstract:This paper proposes a novel multirate co-simulation method to improve simulation efficiency of large-scale AC plus multiterminal DC (MTDC) grids. In this method, the whole system is partitioned into different AC and MTDC subsystems. They each are simulated with different time steps according to their requirements of accuracy. Unlike the existing methods where simplified models are adopted, the proposed approach fully reserves both the detailed behavior of converters and the nonlinear dynamics of large-scale AC systems. To realize the coordination between different subsystems, updating and discretization of the interface models are significant to guarantee the overall numerical accuracy and stability of the co-simulation method. Accordingly, the interface models of the partitioned AC and DC networks are represented by time-varying Thevenin and Norton equivalents. To eliminate the aliasing or time-delay errors, their parameters are derived using moving-window prediction, stepwise correction, and averaging techniques. A numerical oscillation suppression algorithm is developed for the discretization of the interface model. Thus, numerical stability is well guaranteed. The variables inside each subsystem as well as the interfaces, which are derived by augmented network equations (ANEs), are calculated simultaneously. The rate ratio of large AC and MTDC systems is determined based on our proposed criterion of electromagnetic transient simulation accuracy. The effectiveness of the cosimulation method is validated on a practical system integrating large AC and modular-multilevel-converter-based MTDC grids.

Electro-mechanical Co-simulation of Sub-synchronous Resonance

FEA-Based Mathematical Modeling and Simulation for IPMSM Drive with Consideration of Saturation and Cross-Coupling Influence

Analytical Kinetic Model for Accurate Square-slot Stator Natural Frequency Prediction

Field-circuit Coupled Design and Analysis for Permanent Magnet Synchronous Motor System Used in Electric Vehicles

Continuous-Mass-Model-Based Mechanical and Electrical Co-Simulation of SSR and Its Application to a Practical Shaft Failure Event

Modeling and Realization of Multiphase Permanent Magnet Synchronous Motor Variable Speed System

THE SIMULATION STUDY ON CONTROL STRATEGY OF CASCADE BRUSH-LESS VARIABLE-SPEED CONSTANT-FREQUENCY DOUBLY-FED GENERATOR

Design and analysis on switched reluctance motor system using field-circuit coupled method

The Improved Simulation Model for Transient Study of Subsynchronous Resonance During Large Disturbance and Its Engineering Practice

A Phase-Domain Model of Dual Three-Phase Segmented Powered Linear PMSM for Hardware-assisted Real-Time Simulation

Online Estimation of Turbine–generator Shaft Fatigue Loss-of-life Caused by Subsynchronous Resonance

Multi-physics simulation method for automotive motors with variable working conditions based on multi-software combination

Development of Imitation Model of an Electromechanical Energy Converter with a Solid Rotor in ANSYS RMxprt, Maxwell and Twin Builder

Simulation Research of Synchronous Machines Model Based on EMTDC/Pscad

THE COMPLEX TORQUE COEFFICIENT APPROACH'S APPLICABILITY ANALYSIS AND ITS REALIZATION BY TIME DOMAIN SIMULATION

Modeling and Simulation of Electromechanical Coupling Dynamics for Permanent Magnet Synchronous AC Servomotor

A Multirate EMT Co-Simulation of Large AC and MMC-Based MTDC Systems

Steady-state Mathematical Modeling and Simulation of Inter-turn Short Circuit of Field Windings in Synchronous Machines

A Multimass Model With Non-Linear Modal Damping For Ssr Analysis Of Turbine-Generators

Multi-body dynamics and finite element method co-simulation for crankshaft dynamical strength analysis

Modal Damping of Subsynchronous Oscillation on Compensated Transmission Systems