Abstract:Abstract To achieve the net-zero emissions targets, the global share of renewable energy is rapidly increasing. The high penetration of intermittent and variable renewable power necessitates that coal-fired power plants enhance their operational flexibility for peak shaving and frequency regulation. Frequent and rapid start-ups, shutdowns, and peak shaving processes pose significant safety challenges to the steam turbine rotors. This paper investigates the impact of flexible operation on rotor stress. Firstly, an online monitoring model was developed and verified using a finite element model of a steam turbine high-medium pressure rotor. Secondly, the online calculation model was integrated with a dynamic coal-fired unit model developed using the JTopmeret software on the GSE platform, a well-established dynamic simulation tool for nuclear and fossil fuel power plants. Finally, a rotor low-cycle fatigue life assessment model was developed, and the von Mises stress and fatigue life loss under various load variation rates and ranges were determined. As the load variation rate increases, the life loss increases significantly, with maximum von Mises stress amplitudes of 5.2, 6.5 and 7.8 MPa at 1%, 2% and 3% Pe min−1 load variation rates, respectively. Conversely, as the load variation range increases, the life loss decreases substantially, with maximum von Mises stress amplitudes of 9.2 and 5.0 MPa during load variation processes of 50%–75% and 75%–100% THA, respectively. This study provides detailed guidance for optimizing the safe operation and control strategies of coal-fired power plants.

Online Estimation of Turbine–generator Shaft Fatigue Loss-of-life Caused by Subsynchronous Resonance

Fatigue Life Evaluation of Wind Turbine Tower Based on Measured Data

Rotor Angle Stability Analysis and Enhancement of Synchronous Condenser in Large-Scale Renewable Energy Farms

Fatigue Damage Evaluation Of Turbine Generator Due To Multi-Mode Subsynchronous Oscillation

Indirect Load Measurements for Large Floating Horizontal-Axis Tidal Current Turbines

Online analysis method for turbonator shafting fatigue damage caused by subsynchronous oscillation

Coupled Torsional Vibration and Fatigue Damage of Turbine Generator Due to Grid Disturbance

Online Identification Methodology of Field Winding Short Circuit Fault of Turbogenerator

Fault Diagnosis of Inter-turn Short Circuit in Rotor Winding of Doubly-fed Generator Based on Data Fusion of Multi-flux Sensors

Fatigue Damage of Turbine Generator Shafting Caused by Subsynchronous Oscillations

Fatigue Life Estimation of Francis Turbines Based on Experimental Strain Measurements: Review of the Actual Data and Future Trends

Electro-mechanical Co-simulation of Sub-synchronous Resonance

Fault Prediction and Diagnosis of Wind Turbine Generators Using SCADA Data

Stress Analysis and Life Assessment of the Steam Turbine Rotor During Peak Shaving Transient Processes

Fault Prognosis of Wind Turbine Generator Using Scada Data

Continuous-Mass-Model-Based Mechanical and Electrical Co-Simulation of SSR and Its Application to a Practical Shaft Failure Event

Analysis of Fatigue Life of Turbine Generator Rotor

Identifying Torsional Modal Parameters of Large Turbine Generators Based on the Supplementary-Excitation-Signal-Injection Test

Fatigue life prediction of a supercritical steam turbine rotor based on neural networks

A new air gap flux‐based technique to detect loss of field in synchronous generators

Torsional Vibration Analysis and Stress Calculation for the Fault 600MW Steam Turbine Generator Shaft System