Abstract:The 10MW High Temperature Gas Cooled Test Reactor (HTR-10) has been built in Institute of Nuclear and New Energy Technology (INET) and has been operating successfully since the beginning of 2003. The core outlet temperature of HTR-10 is 700℃. To verify the technology of gas-turbine direct cycle, at first INET had a plan to increase its core outlet temperature to 750℃ and use a helium gas turbine instead of the steam generator (then the reactor is called HTR-10GT). Though HTR-10 has good intrinsic safety, the design basic accidents and beyond design basis accidents of HTR-10GT must be analyzed according to China's nuclear regulations due to changed operation parameters. THERMIX code system is used to study the Anticipated Transient Without Scram (ATWS) caused by an earthquake. The gravity acceleration of the earthquake will make the porosity of the pebble bed smaller, which will thus induce a positive reactivity. The packing fraction of the HTR-10GT core will increase to 0.64 from 0.61, while a reactivity of 1.24% will be inserted into a initial core and 0.788% for an equilibrium core. Then the reactor power increased and the temperature of the core increased. When the neutron flux of power measuring range exceeded 123% and the reactor period becomes less than 20 seconds, the reactor should scram. It was supposed that all the control rods in the reflectors had been blocked and the reactor could not scram. Thus the accident went on and the core temperature and the system pressure increased but the reactor shutdown at last because of its natural negative temperature reactivity feedback mechanism. The residual heat would be removed out of the core by the cavity cooling system. During the accident sequence the maximum fuel temperature was 1223℃. If a temperature coefficient error of 20% was considered during analyzing, the peak temperature of the fuel during the ATWS will reach 1266 ℃. It was a little higher than 1230℃--the fuel temperature limitation of HTR-10. Now the sphere fuel used in HTR-10GT will also be used in HTR-PM and the temperature limitation has been raised to 1620℃, so the HTR-10GT is safe during the ATWS caused by an earthquake. The paper also compares the analysis result of HTR10-GT to those of HTR-10. The results shows that the HTR-10GT is still safe during the accident though its operating temperature is higher than HTR-10. The analysis will be helpful to HTR-PM because they have the same outlet temperature of the core.

Phenomena Identification and Ranking Tables Related to the HTR-PM Accident Analysis

Preliminary Phenomena Identification and Ranking Tables on the Subject of the High Temperature Gas-cooled Reactor-Pebble Bed Module Thermal Fluids and Accident Analysis

Thermohydraulic Transient Studies of the Chinese 200mwe HTR-PM for Loss of Forced Cooling Accidents

Air Ingress Analysis for Two Primary Loop Pipes Rupture of HTR-PM

Study on the DLOFC and PLOFC Accidents of the 200 MWe Pebble-Bed Modular High Temperature Gas-Cooled Reactor with TINTE and SPECTRA Codes

ICONE19-43309 ANALYSIS ON ATWS CAUSED BY EARTHQUAKE OF THE HTR-10GT

Study on Air Ingress of the 200 MWe Pebble-Bed Modular High Temperature Gas-Cooled Reactor

Considerations On A Validation Matrix For System Analysis Codes Of Pebble Bed Modular Htrs

Reactivity Accident Due to Control Rod Inadvertent Withdrawal of the 250mw High Temperature Gas-Cooled Reactor

ICONE19-43100 AIR INGRESS ANALYSIS OF CHIMNEY EFFECT FOR SIMULTANEOUS RUPTURE OF TWO PRIMARY PIPES IN THE HTR-PM

Discussion on the Accident Behavior and Accident Management of the HTGR

Steady-state Thermal Fluids Analysis for the HTR-PM Equilibrium Core

Rapid Accident Source Term Estimation (RASTE) for Nuclear Emergency Response in High Temperature Gas Cooled Reactor

Study on Reactor Cavity Cooling System of HTR-PM in DLOFC Accident with TIN-CAVCO Code and SPECTRA Code

Water-Ingress Accident of the 250mw Pebble-Bed Modular High Temperature Gas-Cooled Reactor

Thermal Hydraulic Analysis of High-Temperature Gas-Cooled Reactor Pebble-Bed Module Using a Systematic Parameter Estimation Approach

The ATWS Analysis of One Control Rod Withdrawal out of the HTR-10GT Core

Reactivity accident in a high temperature gas-cooled reactor due to inadvertent withdrawal of control rod

The ATWS analysis of one control rod withdraw out of the HTR-10GT core in addition with bypass valve failure

Air Ingress Analysis of Chimney Effect in the 200 MWe Pebble-Bed Modular High Temperature Gas-Cooled Reactor

The R&D of HTR-STAC Program Package: Source Term Analysis Codes for Pebble-Bed High-Temperature Gas-Cooled Reactor