Abstract:A new technique based on tube shrinkage is proposed for the fabrication of composite archwires. Compared with a traditional pultrusion method, this new technique can avoid any fiber damage during the fabrication and can provide the archwire with a required curvature in its final clinical usage. The present paper focuses on the technique development and mechanical design and validation in terms of constituent materials by using a micromechanics bridging model. Prototype archwire has been fabricated using fiberglass and an epoxy matrix, with a wire diameter of 0.5mm and a 45% fiber volume fraction. Tensile and three-point bending tests have shown that the mechanical performance of the prototype composite archwire is comparable to that of a clinical Ni–Ti archwire. Another purpose of the present paper is to provide an efficient procedure for a critical design of composite archwires. For this to be possible, the ultimate load especially flexural load carrying ability of the composite archwire must be assessed from the knowledge of its constituent properties. However, difficulty exists in doing this, which comes from the fact that the failure of the utmost filament of the composite archwire subjected to initially the maximum bending stress does not imply its ultimate failure. Additional higher loads can still be applied and a progressive failure process is generated. In this paper, the circular archwire was discretized into a number of parallel laminae along its axis direction, and the bridging micromechanics model combined with the classical lamination theory has been applied to understand the progressive failure process with reasonable accuracy. Only the constituent fiber and matrix properties are required for this understanding. Nevertheless, the ultimate bending strength cannot be obtained only based on a stress failure criterion. This is because neither the first-ply nor the last-ply failure corresponds to the ultimate failure. An additional critical deflection (curvature) condition must be employed also. By using both the stress failure and the critical deflection conditions, the predicted load-deflection up to the ultimate failure agrees well with the measured data. Thereafter, different mechanical performances of composite archwires can be tailored before fabrication by choosing suitable constituent materials, their contents, and the archwire diameters. Several design examples have been shown in the paper.

Stress Curve of Fixed Die in the Process of Orthodontic Archwire Bending

Structural Analysis and Dynamics Simulation of Orthodontic Archwire Bending Robot

Bending Process Analysis and Structure Design of Orthodontic Archwire Bending Robot

Analysis and Experimentation of the Robotic System for Archwire Bending

Theoretical Analysis and Experimental Study of Springback Mechanism of Archwire Bending

Springback Mechanism Analysis and Experimentation of Orthodontic Archwire Bending Considering Slip Warping Phenomenon

Springback Mechanism Analysis and Experiments on Robotic Bending of Rectangular Orthodontic Archwire

STUDY FOR IN-PLANE ULTIMATE STRENGTH OF STEEL CIRCULAR ARCHES WITH HORIZONTAL SPRING SUPPORTS

Kinematics analysis and simulation study of an archwire bending robot

Study on Three-Dimensional Digital Expression and Robot Bending Method of Orthodontic Archwire

Structural Design and Simulation Analysis of an Orthodontic Wire Bending Robot

Digital Expression and Interactive Adjustment Method of Personalized Orthodontic Archwire for Robotic Bending

Recent Advances in Orthodontic Archwire Bending Robot System

A Review of the Research Progress of Orthodontic Archwire Bending Robot for Fixed Appliances

Bending Property Analysis and Experimental Study of Orthodontic Wires

Interactive adjustment of individual orthodontic archwire curve

Formed control point planning of orthodontic archwire based on finite point extension method

Establishment and Experiment of Utility Archwire Dynamic Orthodontic Moment Prediction Model

Development of a robotic system for orthodontic archwire bending

Fabrication of a new composite orthodontic archwire and validation by a bridging micromechanics model.

Orthodontic force/torque modeling and experiment of Kitchon root‐controlled auxiliary archwire