Abstract:In this present work, we applied Taguchi’s plan of experimentation as a numerical tool to develop a TiO2 gas sensor. This plan permits us to reduce the number of experimentations and obtain the optimal conditions of factors involved in the development of the sensitive layer. The focal concept is to optimize the TiO2 thin film conductivity by using an L9 (33) orthogonal array based on three important factors of spray pyrolysis deposition (A, concentration of [Ti4+]; B, deposition temperature; and C, spray pyrolysis time). These factors are varied to select the best deposition conditions and to obtain the best conductivity of TiO2 thin films. From the calculation of signal-to-nose ratio (S/N) and the analysis of variance (ANOVA) based on the conductivity values of thin films, the optimal combination of factors is A2B3C3, which corresponds to the concentration [Ti4+] = 0.3 kmol/m3, the deposition temperature T = 500°C and the spray time = 15 min. The validation test confirmed that this combination of deposition parameters is the most optimal to improve the most important TiO2 thin film properties. X-ray diffraction shows a high privileged direction along the (101) plane, large crystallite size of 21.43 nm and low dislocation density of 2.17 × 10−3 nm−2. The Raman modes located at 143 cm−1, 391 cm−1, 512 cm−1 and 633 cm−1 confirmed the purity of anatase TiO2. The images of scanning electron microscopy showed the growth of compact and granular film with an average of grain size of 66.76 nm. The optical analysis showed a transparent semiconductor with large band gap of 3.33 eV. The electrical measurement displayed a good conductivity of TiO2 equal to 280.06 × 10−6 (S m−1). These outcome properties make TiO2 thin film an attractive material for gas sensor applications.

Particle Size and Film Thinness of Tio2 Sensor Prepared by Flame Synthesis

Synthesis of flowerlike nano-SnO2 and a study of its gas sensing response

Pd-doped TiO2 Film Sensors Prepared by Premixed Stagnation Flames for CO and NH3 Gas Sensing

Characterization and photocatalytic activity of Ni-doped tiO2 nano photocatalysts prepared by low temperature combustion synthesis]

Preparation of tin oxide films for micro gas sensors

High Performance Novel Gas Sensor Device for Site Environmental Protection Using Ti0.5Sn0.5O2 Nanomaterials

Facile Preparation of Size-Controlled TiO2 Nanoparticles by Hot-Filament Metal Oxide Deposition Method and Their Gas Sensing Properties to NO2

Preparation and Gas Sensitivities of Monoclinic TiO2

Study On Design And Properties Of Paper-Based Nano-Sized Tio(2) Gas Sensor

Investigations on TiO2–NiO@In2O3 nanocomposite thin films (NCTFs) for gas sensing: synthesis, physical characterization, and detection of NO2 and H2S gas sensors

Gas Sensing Characteristics of Nano-Structured Metal Oxides

Flame Spray Pyrolysis Synthesis of WO3 Sensing Materials: Effects of Flame Parameters on Particle Size Distribution and NO2 Sensing Performance.

Flame Spray Pyrolysis Synthesis of WO 3 Sensing Materials: Effects of Flame Parameters on Particle Size Distribution and NO 2 Sensing Performance

Quench-Ring Assisted Flame Synthesis of SiO<sub>2</sub>-TiO<sub>2</sub> Nanostructured Composite

Optimization with Taguchi Approach to Prepare Pure TiO2 Thin Films for Future Gas Sensor Application

Synthesis and Optical Properties of Tio2 Nanoparticles

Control of Size and Crystal Form of TiO_2 Nanocrystalline Synthesized by Co-flow Diffusion Flames

Flame Spray Synthesis of SnO2 Nanorods and Their Gas Sensing Properties

Controlled synthesis of nano-sized TiO_2 powders using high-temperature vapor phase process

Direct Synthesis of Nanostructured Tio2 Films with Controlled Morphologies by Stagnation Swirl Flames

The Initial Stages of Multicomponent Particle Formation During the Gas Phase Combustion Synthesis of Mixed SiO2/TiO2