Abstract:Potassium removal from biomass combustion flue gas is important in power engineering because potassium may cause serious problems such as the agglomeration, contamination, corrosion and deposition of heating surfaces. It is feasible to capture potassium vapor in flue gas by solid adsorbents. Experiments were performed to study the reaction characteristics and mechanism of the potassium adsorption by coal ashes with KCl as the alkali model compound. The influences of adsorption temperature, alkali metal concentration and adsorption atmosphere on potassium removal were analyzed. The experimental results confirm that coal ash has a good ability of potassium adsorption. The potassium adsorption amount by coal ash in initial 2h increases roughly linearly with the increase of alkali metal concentration. Potassium adsorption by Guizhou coal ash during the fixed adsorption period increases with the increasing temperature in the range of 650–900°C; while the reaction temperature is over 900°C, potassium adsorption by Guizhou coal ash begins to decline. The potassium adsorption under the conditions even with a little water vapor content is larger than that under the conditions without water vapor. However the effect of high water vapor content on the alkali adsorption capacity is not obvious. The alkali adsorption by coal ash sorbent at a given period is the highest in reducing atmosphere, the second in the conventional flue gas atmosphere and the lowest in the oxyfuel combustion flue gas. The present experimental results will provide the references for the development of economical efficient sorbent of alkali metal to reduce the harm of the alkali in the biomass combustion or gasification process.

12th International Conference on Fluidized Bed Technology EXPERIMENTAL STUDY OF ADSORPTION OF ALKALI WITH BED MATERIAL WHEN CO-FIRING BIOMASS WITH COAL

Experimental study of adsorption of alkali with bed material when co-firing biomass with coal

A basic study on the nano CaO-based CO2 adsorbents in FFB for CO2 capture

Experimental Study of Alkali Salt Adsorption in a Circulating Fluidized Bed Boiler

12th International Conference on Fluidized Bed Technology EFFECT OF ADDITIVES ON THE ASH FUSION TEMPERATURE

Investigation of Ash Deposition Dynamic Process in an Industrial Biomass CFB Boiler Burning High-Alkali and Low-Chlorine Fuel

Investigation on Sodium Fate for High Alkali Coal During Circulating Fluidized Bed Combustion

CFD modeling of sodium transformation during high-alkali coal combustion in a large-scale circulating fluidized bed boiler

Ash deposition behavior of a high-alkali coal in circulating fluidized bed combustion at different bed temperatures and the effect of kaolin

Experimental Study of Extracting Alumina from Coal Fly Ash Using Fluidized Beds at High Temperature

Experimental study on ash deposition and corrosion in a CFB boiler co-firing biomass with coal

An experimental investigation into the effect of flue gas recirculation on ash deposition and Na migration behaviour in circulating fluidized bed during combustion of high sodium Zhundong lignite

Adsorption of Alkali Metal by High-temperature Acid-treated Coal Char

Experiments on Ash Formation of Different Coals in Circulating Fluidized Bed Combustion

Investigation of Ash Deposition Characteristics in Full-Scale Circulating Fluidized Bed Boiler Burning Zhundong Coal

Experimental research on fully burning high-alkali coal in a 300 MW boiler with slag-tap furnace

THE TRANSPORTATION AND TRANSFORMATION OF ALKALI METALS IN STRAW-FIRED CFB BOILERS

Effects of Coal Bottom Ash on Deposit in a Full-Scale Biomass-Fired Circulating Fluidized Bed Boiler

Experimental Study on Adsorption of Potassium Vapor in Flue Gas by Coal Ash

Experimental Investigation on the Combustion and Heat Transfer Characteristics of Wide Size Biomass Co-Firing in 0.2 MW Circulating Fluidized Bed

An experimental investigation into bed particle agglomeration and ash deposition during circulating fluidized bed gasification of Zhundong lignite