Abstract:A novel Rayleigh Doppler lidar technology based on a quadruple dual-pass Fabry–Perot interferometer (FPI) that can accurately measure wind field, temperature and aerosol backscatter ratio from the troposphere to lower stratosphere is proposed. This study aims to analyse the detection principle of wind speed, temperature and aerosol backscatter ratio in detail and obtain their measurement error formulas. The structure of this type of lidar is studied and designed. The FPI consists of two edge channels FPI-1 and FPI-2, aerosol channel FPI-M and locking channel FPI-L. FPI-1, FPI-2 and FPI-M use a dual-pass optical path, whereas FPI-L uses a single-pass optical path. The parameters of FPI are optimised as follows: the free spectral spacing (FSR) is 12 GHz, the FWHM of FPI-1 and FPI-2 are both 2.2 GHz, the peak-to-peak interval of FPI-1 and FPI-2 is 5.8 GHz, the FWHM of FPI-M and FPI-L are both 1.2 GHz, the peak-to-peak interval of FPI-M and FPI-1 is 2.9 GHz and the peak-to-peak interval of FPI-L and FPI-1 is 2.3 GHz. Under simulated atmospheric conditions, for a daytime sky background brightness of 0.3 Wsr −1 m −2 nm −1 at 355 nm, using a laser with a pulse energy of 350 mJ and a repetition frequency of 50 Hz and a telescope with a 0.45-m aperture, with a vertical range resolution of 30 m at 0–10 km, 100 m at 10–20 km and 500 m at 20–35km, temporal resolution of 30 min, zenith angle of 0° for temperature and aerosol backscatter ratio detection and temporal resolution of 3 min and zenith angle of 30° for radial wind speed detection, the detection performance of the designed Rayleigh Doppler lidar is determined. The simulation results show that the measurement errors of aerosol backscatter ratio, temperature and radial wind speed of the lidar system in the daytime and night-time are less than 4.36 × 10 −3 and 3.32 × 10 −3 (excluding cirrus cloud area), 4.0 K and 3.0 K and 3.8 m/s and 1.9 m/s, respectively, from an altitude of 0.06 to 35km.

A Method of Measuring FP Transmittance Based on Whispering Gallery Mode Light Source

Comparisons Between Field-Widen Michelson Interferometer and Fabry-Perot Interferometer As the Spectroscopic Filter in High Spectral Resolution Lidar

Long Focal-Length Measurement Using Divergent Beam and Two Gratings of Different Periods.

A Spectroscopic Transmittance Analytical Modeling for Field-Widened Michelson Interferometer Employed by High Spectral Resolution Lidars

Development of A Field-Widened Michelson Spectroscopic Filter for A Polarized Near-Infrared High Spectral Resolution Lidar

Quad-Fabry-Perot etalon based Rayleigh Doppler lidar for 0.2-60km altitude wind, temperature and aerosol accurate measurement

Effective transmittance of Fabry–Perot cavity under non-parallel beam incidence

High-spectral-resolution Mie Doppler lidar based on a two-stage Fabry–Perot etalon for tropospheric wind and aerosol accurate measurement

Experimental Analysis on the Rapid Measurement of a High Precision Brillouin Scattering Spectrum in Water Using a Fabry–Pérot Etalon

Application of Levenberg-Marquardt Algorithm in the Wind Lidar

Fabry–Pérot based short pulsed laser linewidth measurement with enhanced spectral resolution

New method of the length measurement of FP (Fabry-Perot) cavity

Doppler Wind Lidar Based on Fabry-Perot Etalon

A new Lidar technology using frequency comb light source

Pulsed Laser Linewidth Measurement Using Fabry–Pérot Scanning Interferometer

All-fiber Upconversion High Spectral Resolution Wind Lidar Using a Fabry-Perot Interferometer

Rayleigh Doppler Lidar Technology Based on a Quadruple Dual-pass Fabry–Perot Interferometer

Gap Thickness Retrieval On Air Etalon By Using A Focused Incoherent White-Light Beam

Scanning Rayleigh Doppler Lidar for Wind Profiling Based on Non-polarized Beam Splitter Cube Optically Contacted FPI

The Impacts of Deformed Fabry–Perot Interferometer Transmission Spectrum on Wind Lidar Measurements

Experimental Analysis On Calibration Of Instrument Broadening In A Lidar System With Fabry-Perot Etalon