Abstract:The application of RF cavity beam position monitors (CBPM) is essential for precise beam position measurements in X-ray Free-Electron Lasers (XFEL) and linear colliders. This paper addresses the solution to the inter-bunch signal interference when the bunch separation is as short as nanoseconds. The signals can overlap from bunch to bunch, which can induce appreciable error in evaluating beam position. We propose a conceptual method to eliminate the dominant signal overlap under a quadrature phase offset condition. Using this method, the elimination automatically occurs in the process of signal digitalization. The dominant interference that is contributed by the last bunch can be reduced over an order of magnitude in a conventional CBPM system. In addition, the required bandwidth can be effectively reduced by a factor of 2, and the design challenge for a wideband CBPM is relaxed. The method was demonstrated in an analytic approach by simulating the signal evolution in the RF front end of electronics built in MATLAB code. In the practical concern of applying this method, the factors that perturb the elimination have been examined as well. Based on the numerical result, the CBPM prototype has been designed for the pre-research plan of future high repetition rate hard XFEL at Chinese Academy of Engineering Physics. The combined simulations in CST and MATLAB on the CBPM prototype indicate agreement with the result obtained in the analytic approach.

DESIGN AND SIMULATION OF THE WAVEGUIDE COUPLER FOR THE CAVITY BEAM MONITOR

Design of a Beam-coupling System for a Chip-integrated Spectrometer with a Discrete Linear Waveguide

Design and Measurement of Signal Processing System for Cavity Beam Position Monitor

Research of Coupling Coefficient Extraction of a Cavity Resonator

A Multilayer Dual-Band Coupler Based on Composite Right/left-Handed Folded Substrate Integrated Waveguide

Simulation and Experiments for the Q(Ext) of A Cavity Beam Position Monitor

A method of bunch by bunch measurement at nanoseconds interval by using cavity beam position monitors

DEVELOPMENT OF THE SIMULATION SOFTWARE PACKAGE FOR THE CBPM SYSTEM *

Study of the Crosstalk Evaluation for Cavity BPM

Cavity Beam Position Monitor Test System Based on Virtual Instrument

Calculation of the coupling coefficients for spatial waveguides using the field matching method

COMPARISON OF MEASURED AND CALCULATED COUPLING BETWEEN A WAVEGUIDE AND AN RF CAVITY USING CST Microwave Studio

Characteristic Analysis of Spatial Multiwaveguide System Based on Weakly Coupled-Mode Theory

Propagation Characteristic Analysis and Applications of Spatial Four-Waveguide System

Design and Simulation of Coupling Slot Tuning Structure of Two-Gap Coupled Cavity

Analytical model of spatial four-waveguide coupler

Single-mode Fiber Auto-Coupling System with Wedges

Design and cold test of a rectangular cavity beam position monitor

Design and Simulation of a high order mode cavity bunch length monitor

STUDY OF HOM COUPLERS ON AN 800MHz PROTOTYPE CAVITY