Abstract:A larger (6.1 L) MFC stack made in a scalable configuration was constructed with four anode modules and three (two-sided) cathode modules, and tested at a wastewater treatment plant for performance in terms of chemical oxygen demand (COD) removal and power generation. Domestic wastewater was fed either in parallel (raw wastewater to each individual anode module) or series (sequentially through the chambers), with the flow direction either alternated every one or two days or kept fixed in a single direction over time. The largest impact on performance was the wastewater COD concentration, which greatly impacted power production, but did not affect the percentage of COD removal. With higher COD concentrations (similar to 500 mg L-1) and alternating flow conditions, power generation was primarily limited by the cathode specific area. In alternating flow operation, anode modules connected to two cathodes produced an average maximum power density of 6.0 +/- 0.4 W m(-3), which was 1.9 +/- 0.2 times that obtained for anodes connected to a single cathode. In fixed flow operation, a large subsequent decrease in COD influent concentration greatly reduced power production independent of reactor operation in parallel or serial flow modes. Anode modules connected to two cathodes did not consistently produce more power than the anodes connected to a single cathode, indicating power production became limited by restricted anode performance at low CODs. Cyclic voltammetry and electrochemical impedance spectroscopy data supported restricted anode performance with low COD. These results demonstrate that maintaining power production of MFC stack requires higher influent and effluent COD concentrations. However, overall performance of the MFC in terms of COD removal was not affected by operational modes. (C) 2016 Elsevier Ltd. All rights reserved.

Effect of inoculums on performance of microbial fuel cells for simultaneous Congo red decolorization and electricity generation

Effect of Electricity on Microbial Community of Microbial Fuel Cell Simultaneously Treating Sulfide and Nitrate

Improved Simultaneous Decolorization and Power Generation in a Microbial Fuel Cell with the Sponge Anode Modified by Polyaniline and Chitosan

Improved Performance of Microbial Fuel Cells Enriched with Natural Microbial Inocula and Treated by Electrical Current

Effect of cathode electron acceptors on simultaneous anaerobic sulfide and nitrate removal in microbial fuel cell

Effects of Co-substrates on Simultaneous Decolorization of Azo Dye and Bioelectricity Generation in Microbial Fuel Cell Coupled Constructed Wetland

Feasibility study of simultaneous azo dye decolorization and bioelectricity generation by microbial fuel cell-coupled constructed wetland: substrate effects

of simultaneous azo dye decolorization and bioelectricity generation by microbial fuel cell-coupled constructed wetland : substrate e ff ects

Performance of Microbial Fuel Cell Coupled Constructed Wetland System for Decolorization of Azo Dye and Bioelectricity Generation

Construction of double tube granular sludge microbial fuel cell and its characteristics and mechanism of azo dye degradation

The Effect of Electricity Generation on the Performance of Microbial Fuel Cells for Anammox

A Microbial Fuel Cell Producing Electricity Directly from Municipal Wastewater Treatment

Simultaneous enhancement of power generation and chlorophenol degradation in nonmodified microbial fuel cells using an electroactive biofilm carbon felt anode

Effect of nitrate concentration on power generation and nitrogen removal in microbial fuel cell

The Effect of Fl Ow Modes and Electrode Combinations on the Performance of a Multiple Module Microbial Fuel Cell Installed at Wastewater Treatment Plant

Comparison analysis on simultaneous decolorization of Congo red and electricity generation in microbial fuel cell (MFC) with l-threonine-/conductive polymer-modified anodes

Treatment of colour industry wastewaters with concomitant bioelectricity production in a sequential stacked mono-chamber microbial fuel cells–aerobic system

Fe-N-C-based cathode catalyst enhances redox reaction performance of microbial fuel cells: Azo dyes degradation accompanied by electricity generation

Biodegradation of Congo Red Using Co-Culture Anode Inoculum in a Microbial Fuel Cell

Microbial fuel cell in long-term operation and providing electricity for intermittent aeration to remove contaminants from sewage

[Effects of Microbial Fuel Cell Coupled Constructed Wetland with Different Support Matrix and Cathode Areas on the Degradation of Azo Dye and Electricity Production].