Abstract:In this paper, the stress-strain state and the effectiveness of shear resistance of a glass fiber-reinforced polymer (GFRP) bar soil nail in a pullout test was studied in laboratory using fiber Bragg grating (FBG) sensing measurement. Both experimental study and numerical simulation were carried out and results are compared in this paper. In the pullout test, cement slurry was grouted into one predrilled borehole with a GFRP bar in a completely decomposed granite (CDG) soil mass, forming a cement-grouted GFRP bar soil nail. This GFRP bar soil nail was pulled out from the CDG soil mass in laboratory to investigate the performance of the GFRP bar soil nail during the pullout test process. Three loading cycles were applied to pull the GFRP bar soil nail out. Compared with traditional electricity-based strain gauges, FBG sensing technique is a relative novel technology to geotechnical structures health monitoring and has a number of advantages including high accuracy, multiplexing, electromagnetic interference resistance, and good repeatability. In the current study, one fiber line had a series of FBG strain sensors with a sequence of initial wavelengths. This fiber line with five FBG strain sensors was adhered on the pregrooved GFRP bar before grouting and was used to measure the strain distribution along this GFRP bar with cement grout during a pullout test. The mechanical behavior of the GFRP bar soil nail is evaluated by using the measured strain results in the paper. It is found that the pullout results of the GFRP bar soil nail are in good agreement with numerical calculation results. Test results also show that the FBG sensors are reliable for measuring the strain variation at all measured points under different loading stages. Furthermore, a simplified pullout resistance model originally proposed for GFRP pipe soil nails was employed to examine the laboratory pullout results of a GFRP bar soil nail. It is found that the simplified pullout resistance model is also applicable for the GFRP bar soil nail. (C) 2013 American Society of Civil Engineers.

On the effects of grouting pressure and overburden pressure on the pullout resistance of soil nails

Performance of a Compaction-Grouted Soil Nail in Laboratory Tests

Experimental study of the direct shear characteristics of cement grout under constant normal loading and stiffness boundary conditions

New slurry pressure type soil-nailing technology and its working mechanism

Performance Monitoring of A Glass Fiber-Reinforced Polymer Bar Soil Nail During Laboratory Pullout Test Using Fbg Sensing Technology

The Compaction Effect on the Performance of a Compaction-Grouted Soil Nail in Sand

New test facility for studying the behaviour of pressure-grouted soil nails

Stress distribution of reinforcement of reinforced soil structures under drawing force

Negative Effect of Installation on Performance of a Compaction-Grouted Soil Nail in Poorly Graded Stockton Beach Sand

The Influence of the Degree of Saturation on Compaction-Grouted Soil Nails in Sand

Field Pullout Testing and Performance Evaluation of GFRP Soil Nails

Time-Dependent Pullout Behavior Of Glass Fiber Reinforced Polymer (Gfrp) Soil Nail In Sand

Field and Laboratory Investigation of Pullout Resistance of Steel Anchors in Rock

PULL-OUT BEHAVIOR OF THE INTERFACE BETWEEN GEOGRID AND COMPACTED EXPANSIVE SOIL

A cavity expansion theory-based hyperbolic model for the pull-out force of a compaction-grouted soil nail

Effect of Cemented Soil Properties on the Behavior of Pre-Bored Grouted Planted Nodular Piles under Compression

Evaluations of Load-Deformation Behavior of Soil Nail Using Hyperbolic Pullout Model

Performance Tests on Pressure-Dispersed Compression Anchors in Cohesive Soils

Study on shear stress distribution of glass fiber reinforced polymer soil nail in foundation pit support pullout test

Testing and Modeling the Behavior of Pre-Bored Grouting Planted Piles under Compression and Tension

TESTING STUDY ON COMPACTED DECOMPOSED GRANITE SOIL