Abstract:Atmospheric line-of-sight (LOS) wind measurement by means of incoherent Cabannes-Mie lidar with three frequency analyzers, two double-edge Fabry-Perot interferometers, one at 1064 nm (IR-FPI) and another at 355 nm (UV-FPI), as well as an iodine vapor filter (IVF) at 532 nm, utilizing either a single absorption edge, single edge (se-IVF), or both absorption edges, double edge (de-IVF), was considered in a companion paper [Appl. Opt. 46, 4434 (2007)], assuming known atmospheric temperature and aerosol mixing ratio, R-b. The effects of temperature and aerosol variations on the uncertainty of LOS wind measurements are investigated and it is found that while the effect of temperature variation is small, the variation in R-b can cause significant errors in wind measurements with IVF systems. Thus the means to incorporate a credible determination of R-b into the wind measurement are presented as well as an assessment of the impact on wind measurement uncertainty. Unlike with IVF methods, researchers can take advantage of design flexibility with FPI methods to desensitize either molecular scattering for IR-FPI or aerosol scattering for UV-FPI. The additional wind measurement uncertainty caused by R-b variation with FPI methods is thus negligible for these configurations. Assuming 100,000 photons from Cabannes scattering, and accounting for the R-b measurement incorporated into the IVF method in this paper, it is found that the lowest wind uncertainty at low wind speeds in aerosol-free air is still with UV-FPI, similar to 32% lower than with de-IVF. For 0.05 < R-b < 0.07, the LOS wind uncertainty is lowest with de-IVF, and for R-b > 0.07, the IR-FPI outperforms all other methods. In addition to LOS wind uncertainty comparison under high wind speed conditions, the need of an appropriate and readily available narrowband filter for operating the wind lidar at visible wavelengths under sunlit condition is discussed; with such a filter the degradation of LOS wind measurement attributable to clear sky background is estimated to be 5% or less for practical lidar systems. (C) 2007 Optical Society of America.

A comparative study on Fabry-Perot interferometer and iodine vapor filter for direct-detection Doppler wind measurements with a Cabanne-Mie lidar

Direct-detection Doppler Wind Measurements with a Cabannes–Mie Lidar: A Comparison Between Iodine Vapor Filter and Fabry–Perot Interferometer Methods

Direct-Detection Doppler Wind Measurements With A Cabannes-Mie Lidar: B. Impact Of Aerosol Variation On Iodine Vapor Filter Methods

Comparisons Between Field-Widen Michelson Interferometer and Fabry-Perot Interferometer As the Spectroscopic Filter in High Spectral Resolution Lidar

Fabry-Perot interferometer based Mie Doppler lidar for low tropospheric wind observation

Development of A Field-Widened Michelson Spectroscopic Filter for A Polarized Near-Infrared High Spectral Resolution Lidar

Development and Experimental Testing of a Rotary Direct Wind Lidar System Based on Fabry.Perot Interferometer Technology-=SUP=-*-=/SUP=-

Rayleigh Doppler Lidar Technology Based on a Quadruple Dual-pass Fabry–Perot Interferometer

Low-altitude atmospheric wind measurement from the combined Mie and Rayleigh backscattering by Doppler lidar with an iodine filter

Assessment Of A(1) Three-Frequency Alternate Pulse Doppler Wind Lidar

Rayleigh-Mie Wind Lidar Based on Fabry-Perot Interferometer

A Rotary Platform Mounted Doppler Lidar for Wind Measurements in Upper Troposphere and Stratosphere

Low-Altitude Wind Measurement Using Incoherent Doppler Lidar by Utilizing Both Absorption Slopes of the Iodine Absorption Spectrum

The Impacts of Deformed Fabry–Perot Interferometer Transmission Spectrum on Wind Lidar Measurements

Optimization of scanning Fabry–Perot interferometer in the high spectral resolution lidar for stratospheric temperature detection

Assessment of a multibeam Fizeau wedge interferometer for Doppler wind lidar

Doppler Wind Lidar Sensitivity and Aerosol Backscatter Ratio Measurement by Combined Raman-Mie-Rayleigh Scattering

Comparison of simulated performance of filters in space-borne wind lidar system

Comparison Between High Spectral Iodine Filter and Double-Edge Doppler Wind Lidar Techniques

High-spectral-resolution Mie Doppler lidar based on a two-stage Fabry–Perot etalon for tropospheric wind and aerosol accurate measurement