Numerical Investigation of Passive Corner Separation Control Using a Micro-blade in an Annular Compressor Cascade

Bo Wang

2017-01-01

Abstract:Corner separation is a universal flow phenomenon in a compressor. It contributes greatly to loss and passage blockage in the compressor stage. In order to mitigate the corner separation and improve the performance of compressor cascade, a new flow control method, a microblade installed on the endwall upstream of the separation onset location, was proposed on the basis of the comprehension of the flow field characteristics on the juncture of the endwall and blade region. A numerical investigation was performed in an annular compressor cascade to assess the effectiveness of micro-blade. The results show that the cascade aerodynamic performance under incidence from +2.2° to +10° is improved after a micro-blade installed, and the decrease of total pressure loss coefficient and the increase of static pressure rise was achieved. Furthermore, the blockage of the cascade is restrained and flow deflection angle increased. To understand the flow physics of the underlying mechanism of micro-blade, detailed analysis of predicted flow field was carried out. It indicates that a local high static pressure region which is resulted from the concave curvature of the micro-blade pressure surface appeared on the suction surface to accelerate flow upstream of separation onset location. The acceleration of flow produced a jet to reduce the thickness of boundary layer on the suction surface. Also, the jet can build a “jet barrier” near the endwall to hinder the accumulation of low momentum flow transported by passage cross flow. INTRODUCTION Corner separation is an inherent flow feature in the junction of the suction surface and endwall of axial compressors (Gbadebo, 2005). From former researches, this kind of three-dimensional separation can lead to blockage and loss from downstream mixing which has negative effects on stability and efficiency of axial compressors (Dring, 1982; Joslyn, 1985; Choi, 2006; Yamada, 2016). With stage loading of axial compressors increasing, the corresponding increase of cross passage pressure gradient and streamwise adverse pressure gradient is unavoidable. Therefore, corner separation gradually becomes one of the most essential limiting factors on high-loaded axial compressor performance and operability. In order to control the negative effects due to corner separation and to improve the performance of high-loaded compressor, many active and passive flow control methods have been proposed. Concerning development of active flow control method, a number of studies show that the active flow control methods, such as boundary layer suction (Peacock, 1965), boundary layer jet (Nerger, 2010), vortex generator jet (Feng, 2015) as well as plasma actuation(Li, 2010), have capacity to suppress corner separation. Due to complexity of actuation system and requirement of energy input, these flow control methods were not pursued for practical application. Compared with active flow control, passive flow control methods can be achieved easily by device with relatively simple configuration and don’t require any external energy