Simple multiplexing schemes for sensor networks exploiting low coherence interferometry

B. L. Ribeiro,T. Y. Liu,Y. J. Rao,D. A. Jackson

1998-01-01

Abstract:Introduction Low coherence interferometry offers the possibility of solving the ‘powering up’ problem associated with all fibre optic interferometric sensors used to measure slowly varying measurands such as temperature or displacement. In a typical system, the remote sensor is illuminated with the output form a source with low temporal coherence and interrogated using a second interferometer which is scanned such that its optical path difference (OPD) is maintained to be exactly equal to that of the sensor. In order that fibre optic sensors can compete with conventional electronic sensors it is desirable to be able to multiplex several sensors. A variety of multiplexing configurations for interferometric sensors exploiting low coherence processing have been developed, which include coherence tuning(l) and time division multiplexing (TDM)(2). Practical difficulties are experienced with both techniques. The main problems with coherence tuning are i) the optical path length of each sensor must be different (incremented by the source coherence length) which imposes restrictions on the sensor designs, particularly in the case for a network of miniature sensors, and ii) very high cross talk levels, as the recovered signal contains both the desired signal for the coherence tuned sensor and uncorrelated optical power from all the other sensors in the network, which inevitably results in very poor S/N ratios. The noise associated with the uncorrelated signals can be eliminated by exploiting TDM, however, as it is necessary to sequentially coherence match the local receiving interferometer (LRI) to each sensor, the technique is difficult to use in practice. Here we report two novel partially multiplexed configurations where the problems listed above can be solved by fully multiplexing the scanning interferometer and the signal processing unit, whilst at the same time the sensor network is only partially multiplexed. Configuration (1) Long Rang Tracking The basic optical configuration for long range tracking is shown in figure la. The output beam from a low coherence optical source (LCOS) is first collimated and directed into the transmission Michelson interferometer (TMI). The output signal of this interferometer is then injected into a 50/50 multimode coupler and then used to illuminate the two bulk optic Michelson interferometers acting as sensor simulators.