Abstract:Introduction Low coherence interferometry offers the possibility of solving the ‘powering up’ problem associated with all fibre optic interferometric sensors used to measure slowly varying measurands such as temperature or displacement. In a typical system, the remote sensor is illuminated with the output form a source with low temporal coherence and interrogated using a second interferometer which is scanned such that its optical path difference (OPD) is maintained to be exactly equal to that of the sensor. In order that fibre optic sensors can compete with conventional electronic sensors it is desirable to be able to multiplex several sensors. A variety of multiplexing configurations for interferometric sensors exploiting low coherence processing have been developed, which include coherence tuning(l) and time division multiplexing (TDM)(2). Practical difficulties are experienced with both techniques. The main problems with coherence tuning are i) the optical path length of each sensor must be different (incremented by the source coherence length) which imposes restrictions on the sensor designs, particularly in the case for a network of miniature sensors, and ii) very high cross talk levels, as the recovered signal contains both the desired signal for the coherence tuned sensor and uncorrelated optical power from all the other sensors in the network, which inevitably results in very poor S/N ratios. The noise associated with the uncorrelated signals can be eliminated by exploiting TDM, however, as it is necessary to sequentially coherence match the local receiving interferometer (LRI) to each sensor, the technique is difficult to use in practice. Here we report two novel partially multiplexed configurations where the problems listed above can be solved by fully multiplexing the scanning interferometer and the signal processing unit, whilst at the same time the sensor network is only partially multiplexed. Configuration (1) Long Rang Tracking The basic optical configuration for long range tracking is shown in figure la. The output beam from a low coherence optical source (LCOS) is first collimated and directed into the transmission Michelson interferometer (TMI). The output signal of this interferometer is then injected into a 50/50 multimode coupler and then used to illuminate the two bulk optic Michelson interferometers acting as sensor simulators.

Multiplexing of interferometric sensors using phase-generated carrier techniques

Time-division multiplexing of interferometric fiber sensors using passive phase-generated carrier interrogation.

Prototype Multiplexing System for Use with a Large Number of Fiber Optic Based Extrinsic Fabry-Perot Sensors Exploiting Low-Coherence Interrogation

Simple multiplexing schemes for sensor networks exploiting low coherence interferometry

A coarse wavelength-division-multiplexed extrinsic fiber fabry-perot sensor system

Multiplexing of Fabry-Pérot Sensor by Frequency Modulated Continuous Wave Interferometry for Quais-Distributed Sensing Application

Multiplexing interrogation of interferometric sensors using dual multimode laser diode sources and coherence reading

Fibre segment interferometry using code-division multiplexed optical signal processing for strain sensing applications

Fiberoptic Security System Based on Phase Carrier Multiplexing and Its Realization Methods

Multiplexing technique of optical fiber displacement sensor based on heterodyne interference with frequency-modulated semiconductor laser

Phase-shifted demodulation scheme for fiber-optic interferometric sensors with combined waveform phase modulation

Multiplexing Optical Fiber Displacement Sensor Based on Heterodyne Interference with Frequency-Modulated Laser Diode

Hybrid wavelength- and frequency-division multiplexed fiber laser sensor array.

Crosstalk suppression of extrinsic Fabry-Perot interferometric sensor array based on five-step phase shift demodulation scheme using multiwavelength averaging

Optical Coherence-Multiplexed Sensors Based on In-Fiber Michelson

Multiplexing Capability Enhancement of Spatial-Frequency-Division-Multiplexed Fizeau Strain Sensors with Pisarenko Algorithm

Multiplexing Fiber-Optic Fabry-Perot Acoustic Sensors Using Self-Calibrating Wavelength Shifting Interferometry

Multiplexed Strain Sensing by Synthesis of Optical Coherence Function with Time-Division Phase Shift Modulation

Spread Spectrum Technique For Passive Multiplexing Of Reflective Frequency-Out Fiber Optic Sensors Exhibiting Identical Characteristics

Fiber-Optic Fabry-Perot Sensors Based On A Combination Of Spatial-Frequency Division Multiplexing And Wavelength Division Multiplexing Formed By Chirped Fiber Bragg Grating Pairs

Characteristic phase generated carrier technology for the single-core fiber optic sensing