Magnetic graphene oxide-containing chitosan‐sodium alginate hydrogel beads for highly efficient and sustainable removal of cationic dyes

Jinming Ma,Meng Zhang,Miaomiao Ji,Lexin Zhang,Zhihui Qin,Yaru Zhang,Lili Gao,Tifeng Jiao
DOI: https://doi.org/10.1016/j.ijbiomac.2021.11.054
IF: 8.2
2021-12-01
International Journal of Biological Macromolecules
Abstract:Developing recyclable and efficient adsorbents for cationic dyes removal from wastewater is crucial for ensuring green ecology and drinking water safety. Herein, we demonstrated a novel magnetic gel bead adsorbent that was synthesized by employing graphene oxide (GO) modified Fe<sub>3</sub>O<sub>4</sub> as magnetic nanoparticles doped sodium alginate (SA)/chitosan (CS) gel (SA/GO@Fe<sub>3</sub>O<sub>4</sub>/CS). The GO@Fe<sub>3</sub>O<sub>4</sub> sample was prepared based on GO by the chemical co-precipitation method, which not only reduced the aggregation of Fe<sub>3</sub>O<sub>4</sub> but also increases the specific surface area of the composite gel beads. The prepared gel beads were used to adsorb methylene blue (MB), neutral red (NR), and safranine T (ST). The experimental results showed that the adsorption capacity of SA/GO@Fe<sub>3</sub>O<sub>4</sub>/CS gel beads for MB, NR, and ST reached 21.325 mg/g, 44.654 mg/g and 44.313 mg/g. After five recycles, the removal rates could still reach more than 90% of the original, exhibiting a high recovery rate. Therefore, this paper provides a strategy for the preparation of high efficiency and recyclable cationic dye adsorbents with a large specific surface area.
polymer science,biochemistry & molecular biology,chemistry, applied
What problem does this paper attempt to address?