Abstract:2D and 3D numerical simulations with two-fluid approach were conducted to investigate the gas-liquid flow dynamic behaviour in a rectangle bubble column. In the simulations, k-ε and RNG k-ε turbulent models, which account for the influence of the bubbles on liquid phase turbulence, were employed to study the effect of such models on predication of the dynamic behaviour of the bubble plume. In addition, the influence of different interfacial force closures such as drag, lift and added mass forces were also assessed. The simulation results indicated that for the 2D cases, the use of k-ε model could merely yield a steady flow pattern with one big liquid circulation, while the use of RNG k-ε model could produce a steady flow pattern, characterised by the appearance of three large vortices. However, all the 3D simulations have captured the plume meandering behaviour. The results showed that the value of the turbulence eddy viscosity predicted with 3D simulation was one order smaller than that with 2D simulation. Particularly, the meandering period of the bubble plume predicted by RNG k-ε model, was obviously smaller than that predicted using k-ε model in 3D simulations. The former gave the average turbulence eddy viscosity to be almost one third of that predicted by the latter. The assessment of the use of different interfacial force closures and their combinations showed that the lift force has a pronounced effect on the result of bubbly flow behaviour besides the drag force. It was found that the predicted meandering period was much greater than the experimental observations without the inclusion of the lift force, while the predicted period was consistent with the experimental result when the lift force was considered. Our simulations also revealed that the inclusion of the added mass force could notably improve the prediction results.

Approximate Analytical Results for Two-Fluid Model of Laminar Bubbly Flow

Integrated Two-Fluid Model for Laminar Bubbly Flow

A Dual-Scale Turbulence Model for Gas–liquid Bubbly Flows

2-D Hydrodynamic Model of Bubble Column Based on Lateral-Force Balance

Numerical Modelling of Bubbling Flow Dynamic Behaviour in a Bubble Column

Novel Bubble–Emulsion Hydrodynamic Model for Gas–Solid Bubbling Fluidized Beds

Multi-fluid Model for Laminar Bubbly Flow in a Vertical Pipe

TWO-FLUID MODEL FOR ADIABATIC LAMINAR BUBBLY FLOW

Mathematic Model of Laminarbubbly Flow

Developed 'laminar' Bubbly Flow with Non-Uniform Bubble Sizes

CFD Simulation of Gas-Liquid Flow in Bubble Column

Modeling of Bubbly Flow using a Combined Volume of Fluid and Discrete Bubble Model: Investigation on Interphase Forces

A k-ε turbulence model for bubbly two phase flow and prediction of liquid velocity and turbulent kinetic energy distribution

Numerical simulation on motion of bubble under water

Numerical Simulation of Two-Phase Flow Using Eulerian-Eulerian Model with One-Group Interfacial Area Transport Equation

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Theoretical analysis and numerical computation of dilute solid/liquid two-phase pipe flow

Experimental and Numerical Study on the Bubble Dynamics Near Two-Connected Walls with an Obtuse Angle

NUMERICAL INVESTIGATION ON TURBULENCE MODELS IN BUBBLY FLOW USING EULER-LAGRANGE APPROACH

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

Improvement of the two-fluid momentum equation for turbulent bubbly flows