Abstract:To accommodate the integration of renewable energy, coal-fired power plants must take on the task of peak regulation, making the low-load operation of boilers increasingly routine. Under low-load conditions, the phase transition point (PTP) of the working fluid fluctuates, leading to potential flow instability, which can compromise boiler safety. In this paper, a one-dimensional coupled dynamic model of the combustion and hydrodynamics of a supercritical boiler is developed on the Modelica/Dymola 2022 platform. The spatial distribution of key thermal parameters in the furnace and the PTP position in the water-cooled wall (WCW) are analyzed in a 660 MW supercritical boiler when parameters on the combustion side change under full-load and low-load conditions. The dynamic response characteristics of the temperature, mass flow rate, and the PTP position are investigated. The results show that the over-fire air (OFA) ratio significantly influences the flue gas temperature distribution. A lower OFA ratio increases the flue gas temperature in the burner zone but reduces it at the furnace exit. The lower OFA ratio leads to a higher fluid temperature and shortens the length of the evaporation section. The temperature difference in the WCW outlet fluid between the 20% and 60% OFA ratios is 11.7 °C under BMCR conditions and 7.4 °C under 50% THA conditions. Under the BMCR and 50% THA conditions, a 5% increase in the coal caloric value raises the flue gas outlet temperature by 32.7 °C and 35.4 °C and the fluid outlet temperature by 6.5 °C and 9.9 °C, respectively. An increase in the coal calorific value reduces the length of the evaporation section. The changes in the length of the evaporation section are −2.95 m, 2.95 m, −2.62 m, and 0.54 m when the coal feeding rate, feedwater flow rate, feedwater temperature, and air supply rate are increased by 5%, respectively.

DYNAMIC MODELING STUDY OF SUPERHEATER STEAM TEMPERATURE BASED ON PRINCIPAL COMPONENT ANALYSIS METHOD AND ONLINE DATA

Research on Thermal Dynamic Processes Based on On-line Data and Principal Component Analysis

Analysis of Superheater’s Pipe Wall Overtemperature by Fault Tree Diagnose

Dynamic Modeling of Integrated Energy Cooling and Heating Supply System Based on System Identification

Performance Online Prediction of Supercritical Boilers Based on Mechanism and Data-driven Model

Dynamic Behavior of Steam Temperature of Supercritical Thermal Power Units

Modeling and Simulation of the Long-term Dynamic Characteristics of a Supercritical Once-through Boiler

A Nonlinear Model Predictive Control Strategy For Superheater Process In Thermal Power Plant

Dynamic Characteristics Analysis on High Parameter Steam Spring-Loaded Safety Valve

Identifiability of Building Thermal System Models Using On-Line Data

Simulation of Dynamic Characteristics of Supercritical Boiler Based on Coupling Model of Combustion and Hydrodynamics

Dynamic Modeling and Simulation of Drum-Steam Pressure Based on Lots of On-Line Data

Dynamic Simulation Model with Virtual Interfaces of Supercritical Working Fluid Heat Exchanger Based on Moving Boundary Method

Research on Hybrid Modeling Simulation Method of Steam Dynamic Transmission and Distribution Process

Dynamic Modeling and Simulation of Unit's Steam Pressure Based on On-line Data and Neural Network

Dynamic Temperature Model of District Heating System Based on Operation Data

The Coupled Process-Component Modeling and Optimization for Heat Exchanger of Supercritical CO2 with Property Variation Based on Heat Current Method

Steam Temperature Characteristics in Boiler Water Wall Tubes Based on Furnace CFD and Hydrodynamic Coupling Model

Engineering Applications of Multi-Model Internal Mode Control for the Superheated Steam Temperature

Prediction of tube temperature distribution of boiler platen superheater by a coupled combustion and hydrodynamic model

Dynamic Modeling of a Thermotechnical Object on the Basis of On-site Data and a Neural Network