Abstract:Pumped storage power is the most mature and cleanest energy in the world, which is universally used in energy recovery fields. As the pumped storage units operate at part-load conditions, typical unstable flow phenomena are universally observed. Guaranteeing the operation stability of the unit is being increasing significant. Since much attention has been paid to the unstable flow characteristic in the hump region, the interaction between the unstable flow and hump characteristic is seldom involved. In present research, comprehensive analysis is systematically conducted to explore unstable flow and its interaction with the hump characteristic in a pump-turbine operated at pump mode. Three typical models, corresponding to the test model, small lean angle model (lean angle theta = 2 degrees) and medium lean angle model (lean angle theta = 10 degrees) representing different flow conditions, i.e., "hump peak", "hump valley" and "stable condition" respectively, are selected for analysis. First, characteristic curves predicted by a modified shear stress transport k-omega partially averaged Navier-Stokes model show good agreements with the experiment data. Then, comprehensive discussions are performed in the blade passage of runner and guide vane. In the runner blade passage, the scale of flow separation near the suction side of the blade increases with increment of the lean angle. In the guide vane, although rotating stall is observed in three models, its scale and intensity are largest under the "hump peak" condition, and alleviated under the "hump valley" and "stable condition". After frequency and its dynamics analysis, it is found that one dominant frequency of 0.088f(n) is induced by the rotating stall evolution. Moreover, as the rotating stall is alleviated under the "stable condition", the dominant frequency captured by the proper orthogonal decomposition (POD) method is transferred to 3f(n), and the hump is also alleviated.

Influence analysis of lower labyrinth pressure pulsation for stability of pumped-storage unit

A Simulation Study of Hydraulic Vibration caused by Clearance Flow in a Pump Turbine

Pressure pulsation analysis of runner and draft tube of pump turbine under different working conditions

Analysis of Inter-blade Vortex and Runner Blades Force of Pump Turbine during Load Rejection Period

Pressure pulsation in small opening operating mode of pump turbine’s turbine mode

Experimental and numerical investigations on pressure pulsation in a pump mode operation of a pump as turbine

Special Pressure Fluctuation analyse of the pump turbine

Analysis on rotor-stator interaction and vibration of pump turbine in pumped storage power station

Mechanism of High Amplitude Low Frequency Fluctuations in a Pump-Turbine in Pump Mode

Analysis of Flow and Runner Dynamic Response Characteristics under Pump Conditions of Variable-Speed Pump Turbine

Dynamic Characteristic Analysis of a Pump-Turbine Unit under the High Pressure Pulsation Operating Condition - Fluid Dynamics Analysis

A Field Investigation of Stability Characteristics of Pressure Fluctuation and Vibration in Prototype Pump Turbine at Multiple Working Points

Vortex motion in vaneless space and runner passage of pump-turbine in S-shaped region

Stability performance of pumped-storage units considering elastic water hammer effects in pressurized piping systems: Mechanism analysis and quantitative criterion

Effect of Operating Head on Dynamic Behavior of a Pump–Turbine Runner in Turbine Mode

Investigations on Pressure Fluctuations in the S-Shaped Region of a Pump–Turbine

Numerical Investigation on the Unstable Flow and Its Interaction with the Hump Characteristic in a Pump Turbine at Pump Mode

Transient Simulation for a Pumped Storage Power Plant Considering Pressure Pulsation Based on Field Test

Reduction of Pressure Pulsation for Pump-Turbine by Variable Speed Operation

Transition of amplitude–frequency characteristic in rotor–stator interaction of a pump-turbine with splitter blades

Flow-Induced Instabilities in Pump-Turbines in China