Abstract:Vortex pumps have good non-clogging performance and are widely used in the fluid transportation of food, sewage treatment, and mineral and coal slurry transportation. In order to design and manufacture a vortex pump with good performance and establish a method of optimum design, we must master the internal flow rules of the pump. Based on the self-design vortex pump (32WB8-12) experiment, the discharge-pump head (qv-H), discharge-pump shaft power (qv-P), discharge-pump efficiency (qv-η), and discharge-critical net positive suction head (qv-NPSHc) curves are obtained, and the qv-NPSHc curve shows an opposite tendency compared with the centrifugal pump. With the mathematical model selected with respect to the optimal condition, the three-dimensional internal flow within the vortex pump has been numerically simulated by a renormalization group k-ε (RNG k-ε) turbulence model. The static pressure (ps) and velocity distribution of the impeller and the middle section of the volute at 0°, 90°, 180°, and 270° are obtained, and the performance curves have been fitted using a CFX-calculated energy parameter. It was illustrated that the velocity field is relatively disordered and the flow in the impeller region is of a forced vortex character. The flow in the volute is similar to that of the combined vortex with backflow, which is a non-axisymmetric unsteady flow with quite high turbulence intensity. These factors are the main reasons for the relatively low efficiency of the vortex pump. The measurement of flow field in volute with a five-hole probe was conducted, and it is demonstrated that the numerical results are in good agreement with the flow field measurement data. An upward pressure gradient forms in the portal area of the impeller, and it is confirmed that the lowest pressure point is located in the upper position of the impeller hub. It is revealed that for the vortex pump to have advanced suction and anti-cavitation performance, the lowest pressure in the pump should be −4 × 104 Pa and it should be located at the center of the vortex chamber cavity.

Signal Measurement and Analysis of the Flow in an Open Pump Sump

Wavelet Cross-Correlation Analysis of the Unsteady Signals of the Flow in the Open Sump

Cyclostationary Approach to Detect Flow-Induced Effects on Vibration Signals from Centrifugal Pumps

Experimental and numerical investigations on pressure pulsation in a pump mode operation of a pump as turbine

The flow research in an open type pump sump by PIV experiments

Measurement of free water surface on non-uniform flow in an open sump

Quantitative Analysis of Energy Loss and Vibration Performance in a Circulating Axial Pump

PIV Experiments on Flow in a Closed Model Pump Suction Sump

PIV Experimental Investigation on the Flow in a Model of Closed Pump Sump

Space-time frequency spectra analyses of the unsteady cavitating vortical flows inside a mixed-flow pump

Flow Measurement in the Model Pump Suction Sump with Baffle by Means of LDV and PIV

A Performance Test and Internal Flow Field Simulation of a Vortex Pump

PIV experimental analysis for the inter flow characteristics in the pump suction sump

Simulation Of The Flow Condition Near The Intake Of A Pump Sump

Mixed-flow pump cavitation characteristics extraction based on power spectrum density through pressure pulsation signal analysis

Cross-influence of cavitation and flow rate on pressure pulsation of a volute mixed flow pump

Model Analysis and System Parameters Investigation for Transient Wave in a Pump–Pipe–Valve System

Wavelet Analysis on Flow Fluctuating Pressure Acting on Plunge Pool Slope

Analysis of Cavitation-induced Vibration Characteristics of a Vortex Pump Based on Adaptive Optimal Kernel Time-frequency Representation

Cavitating Flow Analysis in a Closed Pump Sump

AN EXPERIMENTAL STUDY OF ENTRAINED-AIR VOLUME ON THE NON-UNIFORM FLOW IN AN OPEN PUMP SUMP