Abstract:Vortex pumps have good non-clogging performance and are widely used in the fluid transportation of food, sewage treatment, and mineral and coal slurry transportation. In order to design and manufacture a vortex pump with good performance and establish a method of optimum design, we must master the internal flow rules of the pump. Based on the self-design vortex pump (32WB8-12) experiment, the discharge-pump head (qv-H), discharge-pump shaft power (qv-P), discharge-pump efficiency (qv-η), and discharge-critical net positive suction head (qv-NPSHc) curves are obtained, and the qv-NPSHc curve shows an opposite tendency compared with the centrifugal pump. With the mathematical model selected with respect to the optimal condition, the three-dimensional internal flow within the vortex pump has been numerically simulated by a renormalization group k-ε (RNG k-ε) turbulence model. The static pressure (ps) and velocity distribution of the impeller and the middle section of the volute at 0°, 90°, 180°, and 270° are obtained, and the performance curves have been fitted using a CFX-calculated energy parameter. It was illustrated that the velocity field is relatively disordered and the flow in the impeller region is of a forced vortex character. The flow in the volute is similar to that of the combined vortex with backflow, which is a non-axisymmetric unsteady flow with quite high turbulence intensity. These factors are the main reasons for the relatively low efficiency of the vortex pump. The measurement of flow field in volute with a five-hole probe was conducted, and it is demonstrated that the numerical results are in good agreement with the flow field measurement data. An upward pressure gradient forms in the portal area of the impeller, and it is confirmed that the lowest pressure point is located in the upper position of the impeller hub. It is revealed that for the vortex pump to have advanced suction and anti-cavitation performance, the lowest pressure in the pump should be −4 × 104 Pa and it should be located at the center of the vortex chamber cavity.

AN EXPERIMENTAL STUDY OF ENTRAINED-AIR VOLUME ON THE NON-UNIFORM FLOW IN AN OPEN PUMP SUMP

PIV Experimental Investigation on the Flow in a Model of Closed Pump Sump

Experimental Research On A Pump Suction Sump With Improved Structure

PIV Experiments on Flow in a Closed Model Pump Suction Sump

The flow research in an open type pump sump by PIV experiments

Exploring the Air Impacts on the State Development of Pipe Flow Using the Smooth Particle Hydrodynamic Method

2D Piv Experiments on Non-Uniform Flow in A Rectangular Open Model Pump Suction Passage

Effects of Non-Uniform Inflow on the Spatial and Temporal Distribution of Impeller Excitation in Axial Flow Pumps in Water Tunnels

Simulation Of The Flow Condition Near The Intake Of A Pump Sump

Measurement of free water surface on non-uniform flow in an open sump

PIV experimental analysis for the inter flow characteristics in the pump suction sump

Air Entrained Amount Measurement In The Two-Phase Flow Through Inlet Passage Of Pump

Flow Stability Research in the Pump Sump of Large-Scale Pump Station

Numerical Simulation and Experimental Researeh on Flow in an Open Pump Sump

A Performance Test and Internal Flow Field Simulation of a Vortex Pump

USING THE PIV SYSTEM MEASURING THE FLOW PATTERN OF A SUDDEN ENLARGEMENT FLOW IN AN OPEN TYPE SUCTION CHANNEL OF THE PUMP

Experimental Study on Flow in the Impeller of Low Specific Speed Pump Using Particle Image Velocimetry

An Investigation of Pool Entrainment Based on the Method of Volume of Fluid

Study On Transient Hydrodynamic Performance And Cavitation Characteristic Of High-Speed Mixed-Flow Pump

Effects of Different Inlet Designs on the Water Surface in a Pump Sump

Experiments and numerical analysis of the dynamic flow characteristics of a pump−pipeline system with entrapped air during start-up