Abstract:Key effects of solvent formulations on the structure and morphology of optical-quality yttrium-aluminum nanocomposites using liquid-fed aerosol flame synthesis are investigated. Employing a temperature-controlled flat flame burner with inexpensive nitrates as multi-component precursors, three different solvent formulations, i.e., ethanol, ethanol/2-ethylhexanoic acid (EHA), and butanol, are studied. Adding EHA into ethanol in a 1:1 volume ratio dramatically changes the flame-made yttrium-aluminum oxides from hollow inhomogeneous powders that contain non-uniform large particles to homogeneous nanopowders around 10 nm. As characterized by in-situ phase Doppler anemometry, droplet size with increasing burner height for the EHA/ethanol case remains constant at the beginning, whereas those for both ethanol and butanol cases reduce immediately. EHA likely causes a shift from the droplet-to-particle precipitation route to the gas-toparticle route because of the formed low-boiling-point 2-ethylhexanoates from nitrates via ligand exchange. By replacing ethanol with butanol, hollow particles are produced with better crystallinity because of its high calorific value that helps to heat precursors at the droplet surface. In-situ diagnostics using phase-selective laser-induced breakdown spectroscopy, which tracks only atomic emission from the nanoparticle phase. The result shows that the Al atomic emissions in the EHA/ethanol mixture case gradually increase along the burner height, while those for both ethanol and butanol cases fluctuate, further verifying the favoring of the gas-to-particle route for producing uniform, ultrafine solid multi-oxide particles by adding EHA in solvents. (C) 2018 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Yttrium-Based Nanoparticles:Flame Aerosol Synthesis and Enhanced Infrared Transmittance Properties

Synthesis and Optical Properties of Tio2 Nanoparticles

Direct Synthesis of Nanostructured Tio2 Films with Controlled Morphologies by Stagnation Swirl Flames

Dual Liquid/vapor-Fed Flame Synthesis for the Effective Preparation of SiO2@YAlO3:Nd3+ Nanophosphors

Doping mechanism of Vanadia/Titania nanoparticles in flame synthesis by a novel optical spectroscopy technique

Facile Flame Synthesis and Photoluminescent Properties of Core/shell TiO2/SiO2 Nanoparticles

Phase Formation of Nano-Tio 2 Particles During Flame Spraying with Liquid Feedstock

Synthesis of TiO2 nanoparticles by premixed stagnation swirl flames

Synthesis of Yttria Nanopowders for Transparent Yttria Ceramics

Engineering the Outermost Layers of Tio2 Nanoparticles Using in Situ Mg Doping in A Flame Aerosol Reactor

Surface Characteristics and Microstructure of Dispersed Tio2 Nanoparticles Prepared by Diffusion Flame Combustion

Synthesis of visible light-active nanostructured TiOx (x<2) photocatalysts in a flame aerosol reactor

Study on Y-doped TiO2 Nanoparicles and Their Photocatalytic Properties

Upconversion emission enhancement of TiO<sub>2</sub>coated lanthanide-doped Y<sub>2</sub>O<sub>3</sub>nanoparticles

Upconversion Emission Enhancement of TiO2 Coated Lanthanide-Doped Y2O3 Nanoparticles

Control of Size and Crystal Form of TiO_2 Nanocrystalline Synthesized by Co-flow Diffusion Flames

Flame Synthesis of Ball-in-Shell Structured TiO2 Nanospheres

Laser-Based Investigation of the Transition from Droplets to Nanoparticles in Flame-Assisted Spray Synthesis of Functional Nanoparticles

Flame Sprayed V-doped TiO2 Nanoparticles with Enhanced Photocatalytic Activity under Visible Light Irradiation

Investigating the role of solvent formulations in temperature-controlled liquid-fed aerosol flame synthesis of YAG-based nanoparticles

Synthesis and Characteristics of Fe~(3+)-doped TiO_2 Nanocrystals by Vapour Diffusion Flame Method