Abstract:The response to the COVID-19 epidemic is generating severe shortages of personal protective equipment around the world. In particular, the supply of N95 respirator masks has become severely depleted, with supplies having to be rationed and health care workers having to use masks for prolonged periods in many countries. We sought to test the ability of 7 different decontamination methods: autoclave treatment, ethylene oxide gassing (ETO), low temperature hydrogen peroxide gas plasma (LT-HPGP) treatment, vaporous hydrogen peroxide (VHP) exposure, peracetic acid dry fogging (PAF), ultraviolet C irradiation (UVCI) and moist heat (MH) treatment to decontaminate a variety of different N95 masks following experimental contamination with SARS-CoV-2 or vesicular stomatitis virus as a surrogate. In addition, we sought to determine whether masks would tolerate repeated cycles of decontamination while maintaining structural and functional integrity. All methods except for UVCI were effective in total elimination of viable virus from treated masks. We found that all respirator masks tolerated at least one cycle of all treatment modalities without structural or functional deterioration as assessed by fit testing; filtration efficiency testing results were mostly similar except that a single cycle of LT-HPGP was associated with failures in 3 of 6 masks assessed. VHP, PAF, UVCI, and MH were associated with preserved mask integrity to a minimum of 10 cycles by both fit and filtration testing. A similar result was shown with ethylene oxide gassing to the maximum 3 cycles tested. Pleated, layered non-woven fabric N95 masks retained integrity in fit testing for at least 10 cycles of autoclaving but the molded N95 masks failed after 1 cycle; filtration testing however was intact to 5 cycles for all masks. The successful application of autoclaving for layered, pleated masks may be of particular use to institutions globally due to the virtually universal accessibility of autoclaves in health care settings. Given the ability to modify widely available heating cabinets on hospital wards in well-resourced settings, the application of moist heat may allow local processing of N95 masks.

Heat inactivating and reusing of virus-contaminated disposable medical mask

Can Masks Be Reused After Hot Water Decontamination During the COVID-19 Pandemic?

Feasibility study of reusing surgical masks and evaluation of the effectiveness of different disinfection methods

Decontamination of SARS-CoV-2 and other RNA viruses from N95 level meltblown polypropylene fabric using heat under different humidities

Moist heat as a promising method to decontaminate N95 masks – a large scale clinical study comparing four decontamination modalities: moist heat, steam, ultraviolet-C irradiation and hydrogen peroxide plasma

Exploring Reusability of Disposable Face Masks: Effects of Disinfection Methods on Filtration Efficiency, Breathability, and Fluid Resistance

Feasibility of Reusing Surgical Mask Under Different Disinfection Treatments

Decontamination of N95 masks for re-use employing 7 widely available sterilization methods

Fabrication of a High-Performance and Reusable Planar Face Mask in Response to the COVID-19 Pandemic

Developing home-disinfection and filtration efficiency improvement methods for N95 respirators and surgical facial masks: stretching supplies and better protection during the ongoing COVID-19 Pandemic

Meltblown fabric vs nanofiber membrane, which is better for fabricating personal protective equipments

Ultrafast disinfection of SARS-CoV-2 viruses

Evaluation of filtration effectiveness of various types of facemasks following with different sterilization methods

Inactivation of Severe Acute Respiratory Coronavirus Virus 2 (SARS-CoV-2) and Diverse RNA and DNA Viruses on Three-Dimensionally Printed Surgical Mask Materials

Heat inactivation by high temperature as an approach to combat infections caused by airborne pathogens

Production of Singlet Oxygen from Photosensitizer Erythrosine for Facile Inactivation of Coronavirus on Mask

Water bath is more efficient than hot air oven at thermal inactivation of coronavirus

Fast and Deep Disinfection for Face Masks Recycle Using Vacuum Ultraviolet Irradiation

Autoclave sterilization and ethanol treatment of re-used surgical masks and N95 respirators during COVID-19: impact on their performance and integrity

Respiratory virus deterrence induced by modified mask filter