Abstract:Rotating stall is one of the most important sources of performance deterioration and system instability in axial flow compressors and, therefore, it is of great value for compressor aerodynamic design and the development of active control strategies. It has been widely demonstrated that peculiar flow mechanisms, such as tip clearance leakage vortices, play a decisive role in the genesis of rotating instabilities (RI) and stall inception, however it is still very hard to predict and interpret such mechanisms accurately. This paper presents the results of both experimental and numerical researches dealing with forming process of rotating stall in a 1.5-stage low-speed industrial axial compressor at Harbin Engineering University. A new physical mechanism for explaining the birth of rotating instabilities based on the detection of spike waves is introduced as a result of a deep analysis recognising the role due to low-energy flow migration of along the rotor spanwise direction. To this purpose, transient pressure signals obtained from both experiments and simulations were adopted to describe flow details during onset and scanning pressure contours on the compressor casing were obtained both experimentally and numerically during the process of approaching stall point so that the transition process from RI to the appearance of spike waves could be well captured. The experimental results showed that the frequencies of RI dropped nearly linearly against the flow coefficient and the strength of radial secondary flows increased distinctly, which induces the boundary layer separation near leading edge in the tip region at last. Full-annulus URANS numerical simulations using SST turbulence model were performed and validated adequately by test data, and then employed to capture more flow details and support better understanding of the flow physics. In fact, a lateral tornado-type vortex occurring before the trailing edge backflow and featuring the same frequency of early pressure disturbances was observed numerically. Under the combined effect of the lateral tornado-type vortex and the tip secondary vortex, a trailing edge reverse flow was observed which produced a huge increase of blockage. A radial tornado vortex was formed connecting the suction side and casing wall at the same time finally leading to the spike-wave rotating stall.

Linear to Nonlinear Transition During the Spike Stall Process in a Low Speed Axial Flow Compressor Rotor

Nonlinear Instability of Axial Flow Compression Systems

Surge Process of a High-Speed Axial–Centrifugal Compressor

The role of radial secondary flow in the process of rotating stall for a 1.5-stage axial compressor

Stall Margin Improvement in an Axial Compressor by Continuous and Pulsed Tip Injection

Evolution of unsteady secondary flow structures near the onset of stall in a tip-critical transonic axial flow compressor stage

Experimental investigation of transient characteristics of mild surge and diffuser rotating stall in a centrifugal compressor with vaned diffuser

Numerical investigation of the unsteady tip leakage flow and rotating stall inception in a transonic compressor

Unsteady near-stall flow mechanisms in a transonic compressor rotor at different rotating speeds

Unsteady Flow Behavior due to Breakdown of Tip Leakage Vortex in an Axial Compressor Rotor at Near-Stall Condition

Stall Inception Measurements in a High-Speed Multistage Compressor

Flow Physics During Surge of an Axial-Centrifugal Compressor

Unsteady flow structures in the tip region for a centrifugal compressor impeller before rotating stall

Influence of Rotor-Stator Axial Clearance on Compressor Rotating Stall Characteristics

Experimental Investigation on the Aerodynamic Instability Process of a High-Speed Axial-Centrifugal Compressor

Tip leakage flow, tip aerodynamic loading and rotating instability in a subsonic high-speed axial flow compressor rotor

Effects of rotating inlet distortion on the stall mechanism of an axial flow compressor

Evolution of large-scale flow structures in an axial-flow pump during performance breakdown

Experimental Investigation of Surge and Stall in a High-Speed Centrifugal Compressor

Unsteady Three-Dimensional Flow Phenomena Due to Breakdown of Tip Leakage Vortex in a Transonic Axial Compressor Rotor

Circumferential propagation of tip leakage flow unsteadiness for a low-speed axial compressor