Fatigue Crack Detection Based on Electromagnetic Testing

CAO Yiping,LI Luming,HUANG Gang,DONG Jie,HAO Hongwei,XIE Yixue

DOI: https://doi.org/10.3321/j.issn:1000-0054.2005.11.004

2005-01-01

Abstract:Fatigue cracks must often be measured in bad testing environments where the work piece facet is coated by corrosion.Therefore,electromagnetic testing based on the self-excitation oscillation principle with two-dimensional signal processing was developed to detect fatigue cracks in bad environments.A 45~# steel specimen with artificial defects was used to verify the method.The results show that the sensitivity of the method is more than 3 dB better than conventional methods for the same conditions while lift-off effects are reduced.A 0.1 mm deep artificial surface defect covered by a 0.8 mm thick coating can be detected by the method.