Optimization of heat treatment process after vacuum carburizing of 18Cr2Ni4WA steel

Xu,Zijian,Zhou,Peng,Lu,Jingchen,Wei,Shaopeng,Wang,Gang
DOI: https://doi.org/10.13251/j.issn.0254-6051.2014.09.008
2014-01-01
Abstract:Two different heat treatment processes were conducted to investigate the impact of tempering , quenching and cryogenic process on microstructure and properties of 18Cr2Ni4WA steel after vacuum carburizing .The result shows that after high temperature tempering , quenching , cryogenic and low temperature tempering , the depth of carburized layer is almost not affected and the content of retained austenite on surface is reduced significantly .After 680 ℃×5 h twice tempering +860 ℃ quenching +-115 .3 ℃cryogenic treatment +160 ℃tempering, the surface hardness and the depth of carburized layer is 64.2 HRC and is 0.86 mm respectively, and the microstructure of the carburized layer is composed of acicular tempered martensite , less refined martensite and fine granular dispersed carbides , the microstructure of the core is lath-like tempered martensite , which results in higher surface hardness and good combination of strength and toughness of the core .
What problem does this paper attempt to address?