Abstract:A new type of multileaf oil lubricated foil bearing with flexible supported back spring structure was proposed to satisfy the requirement of high rotating velocity for turbo pump, where the rotor was submerged in the hydraulic oil. The numerical analysis was carried out in this paper. Based on the structure of oil foil bearing, the film thickness model was established without foil deformation. By employing Castigliano's theorem, the total flexibility matrix including the elastic back spring and cantilevered curved beam was calculated, and then compared with commercial finite element software to verify the accuracy of the proposed model. The obtained flexibility matrix was brought into the static and dynamic oil lubricated Reynolds equation. The Reynolds boundary condition was considered to simulate the oil film rupture effect. The deformation equation for the structure and the Reynolds equation were solved coupled by the successive over relaxation method. The static and dynamic characteristics of the oil lubricated multileaf foil bearing with supported back spring were acquired. The effect of the foil thickness on the load capacity was discussed. The variation of the dynamic coefficients with bearing load was acquired. By employing Routh–Hurwitz method, the stability of the bearing was analyzed. The results indicated that the load capacity of the foil bearing with back supported spring was bigger than that of the foil bearing without back supported spring. The stability characteristics of the foil bearing with back supported structure was better than traditional rigid self-acting bearing, particular for the high rotating speed case.

Analysis of Bearing Characteristics of Wave Spring Used in Mechanical Seal

Investigation Into The Performance Of The Vl Seal Based On The 3d Model

Finite element analysis and experimental study of spiral flexure spring

Vibration Analysis of a Nonlinear Rotor-Bearing-seal System

PROCESSING METHODS AND PREDICTIVE MODEL FOR WAVY-TILT-DAM MECHANICAL SEAL

Modeling and dynamics analysis of helical spring under compression using a curved beam element with consideration on contact between its coils

Finite Element Analysis of Reciprocating Sealing Component of Radial Single-piston Pump

Research on Sealing Characteristics of Sealing System Utilizing Spring Energized Seal Ring

Numerical Analysis of the Traction Effect on Reciprocating Seals in the Hydraulic Actuator

Study On Load Capacity And Dynamic Characteristics Of The Wave Bearing At Infinite Compressibility Number

Semi-analytical Fluid-solid Coupling Model for Hydrostatic Mechanical Seals

Performance Analysis of Oil Lubricated Foil Bearing With Flexible Supported Back Spring Structure—Part II: Comparison of Predictions and Measured Test Data

Mechanical Analysis of Spherical Roller Bearings Due to Surface Waviness

An Equivalent Axisymmetric Modeling Approach for Circumferential Springs under Large Deformation Based on Mechanical Anisotropy

Hydrostatic Mechanism of A Wavy-Tilt-Dam Mechanical Seal

Theoretical Analysis on Fluid-Structure Coupling of Hydrostatic Mechanical Seal

Performance analysis of spiral flexure bearing

Coupling Analysis of Frictional Heat of Fluid Film and Thermal Deformation of Mechanical Seal End Faces

Performance Analysis of Oil Lubricated Foil Bearing with Flexible Supported Back Spring Structure-Part I: Model Development and Numerical Investigation

Mechanism of a wavy-tilt-dam mechanical seal under different working conditions

A Study On Performance Of O-Shaped Seal Ring In Lwd Device Using Finite Element Analysis