Experiment Study on Bond Slip Behavior Between Section Steel and Concrete in SRC Structures

YANG Yong,Guo Zixiong,Xue Jianyang,Zhao Hongtie,NIE Jianguo

DOI: https://doi.org/10.3321/j.issn:1000-6869.2005.04.001

2005-01-01

Abstract:A series of push-out tests were conducted to study the bond mechanism, bond strength and bond-slip constitutive relations between section steel and concrete in SRC structures (steel reinforced concrete structures). Sixteen standard push-out specimens are designed based on orthogonal design method, to study the differences of bond performance between exterior surfaces, interior surfaces of flanges as well as web surfaces of the section steel, and four main variables including concrete strength, volume ratios of stirrups as well as embedded length and thicknesses of concrete cover of section steel are taken into account. Four comparison specimens are additionally adopted in which interior surfaces of flanges and web surfaces are isolated from the concrete, to study separately the contribution of exterior surface of flanges to bond strength. From the test results, along the embeded length, the section steel strain is exponentially distributed at load-ascending stage and linearly distributed at load-descending stage respectively. The slip values and its distribution are very close on the interfaces at exterior surface, interior surface of flanges and webs of the section steel. The contribution to total bond strength of exterior surface of flanges is bigger than that of interior surface of flanges and web surfaces at load-descending stage, but there is little difference between contributions of different surfaces at load-ascending stage. According to the experimental load-slip curves reordered at load-end and free-end of all specimens, a set of calculation formulas of three characteristic bond strength and three characteristic slippage values are established by regression method, and the mathematic mode of constitutive relations between average bond stress and slip at load-end which is usually named as -S_L relations is presented.