Abstract:The absorption heat exchanger is a key component in the novel district heating systems based on absorption cycles. It can maintain the primary water return temperature at a quite low level and realize covering more waste heat recycle. Because in most working conditions the temperature drop and rise in a single absorber or evaporator is as high as 20-30 K, the multi-stage structure of this device has been proposed. The theoretical analysis have shown that this kind of structure can make heat transfer process more matched to realize much lower outlet temperature of primary water, while single-stage structure can only achieve a relatively high level. This is because of the multi-stage pressure and temperature gradient. In this study, based on the absorption heat exchanger technology, a vertical three-stage absorber-evaporator experiment unit was designed and built. On a large vacuum test bench, experiments were carried out in different conditions to test the performance. The result shows the experiment unit can achieve large temperature difference on the water side and form three stages of evaporating pressure gradient. With three-stage evaporating pressure gradient, the large triangle heat transfer process disappeared. The most important thing is that it can reduce the water temperature of evaporator side to a low level. Compared with traditional single-stage absorption heat pump, the heat transfer process in the whole absorber and evaporator is more matched and the performance can be better. In the experiment, an important phenomenon shows that the outlet water temperature of the first stage absorber is even higher than the inlet solution temperature. A 1-D differential model was built to analyze and explain the temperature variation inside the device so this experimental phenomenon can be reasonably explained. Finally the experiment unit was directly applied in a real district heating system. It worked as part of a complete multi-stage absorption heat exchanger in one thermal station of the district heating system. The machine has great performance in different heating conditions. It also formed three stages of evaporating pressure gradient. The primary water return temperature, that is, the water outlet temperature of the evaporator, can be as low as 25℃. The temperature level is satisfying and brings lots of benefits to the whole heating system.

Performance Comparison Of Different Design Scheme Of Absorption Boiler

Performance Comparison and Energy Saving Ratio analysis Between Absorption Heat Pump and Gas Engine-driven Heat Pump

Experimental investigations and multi-objective optimization of an air-source absorption heat pump for residential district heating

Performance Analysis on Compression-Assisted Absorption Heat Transformer: A New Low-Temperature Heating System with Higher Heating Capacity under Lower Ambient Temperature

Investigations on the Cycle Performance of a Diffusion Absorption Heat Transformer Using HCOOK As an Alternative to LiBr

Air-source Heat Pump Heating System with a New Temperature and Hydraulic-Balance Control Strategy: A Field Experiment in a Teaching Building

Techno-economic Analysis of Air Source Absorption Heat Pump: Improving Economy from a Design Perspective

Comparisons of different working pairs and cycles on the performance of absorption heat pump for heating and domestic hot water in cold regions

Performance Improvement of Absorption Heat Pump

Experimental Study of Heat Exchanger Basing on Absorption Cycle for Chp System

Theoretical comparisons between absorption heat pump and electrical heat pump for low temperature heating

A Two-Stage Vertical Absorption Heat Exchanger for District Heating System

Experimental Study and Application of Multi-Stage Absorber/ Evaporator Based on Absorption Heat Exchanger

Performance optimization and comparison towards compact and efficient absorption refrigeration system with conventional and emerging absorbers/desorbers

Energy saving potential of low temperature hot water system based on air source absorption heat pump

PERFORMANCE STUDY OF ABSORPTION/COMPRESSION HEAT PUMP (ACHP) SYSTEM BY LOW-TEMPERATUREGEOTHERMAL TAIL WATER

Performance and optimization of absorption heat exchanger under different flow rate ratio conditions

Investigation on Operation Strategy of Absorption Heat Exchanger for District Heating System

Heat and mass transfer performance comparison of various absorbers/desorbers towards compact and efficient absorption heat pumps

Process Design, Performance Comparison and Operating Test of the Multi-Stage Vertical Absorption Heat Exchanger Realizing Independent Heating in Three Zones

Comparison of LCA results of low temperature heat plant using electric heat pump, absorption heat pump and gas-fired boiler