Abstract:In this paper, a calibration method applied to Successive Approximation Register (SAR) Analog-to-Digital Converter (ADC) is designed, especially applied to the capacitive array in resistive–capacitive combined SAR ADC. Conventionally, auxiliary Digital-to-Analog Converter (DAC) foreground calibration, dynamic element matching (DEM) or digital background calibration are widely used to enhance linearity of data converters. This paper proposes an off-line capacitor selection calibration method that uses an optimal sequence of unity elements for an overall improvement of Signal to Noise and Distortion Ratio (SNDR), Spurious-Free Dynamic Range (SFDR), differential nonlinearity (DNL) and integral nonlinearity (INL). It is worth mentioning that the capacitor mismatch only needs to be calibrated after power on, this kind of foreground calibration will not increase the power consumption of ADC during the normal operation, while the background calibration will consume power consumption all the time. It is important that the calibration proposed is highly relied on a high resolution comparator. This paper provides a high resolution comparator design, the resolution of the comparator reaches 8.35 μV, which already satisfies the demand of a 18-bit differential SAR ADC. During the process of calibration, all capacitors are divided into unit capacitors, and then the capacitors are sorted, reorganized to form each bit. The calibration method is verified by simulating a 18-bit SAR ADC with 500 Monte-Carlo runs, the simulation results show that the average value of SFDR is enhanced by about 36 dB and the average value of SNDR is enhanced by about 27 dB. Therefore, the proposed method is simple and significantly improves the static and dynamic performance of the ADC without obvious additional hardware, and greatly saves area and power consumption. Finally, it is worth mentioning that in high-precision SAR ADCs design, especially above 16 bits, comparator noise and the voltage coefficient of capacitors are the main factors limiting ADC performance, which are not considered in this work.

A Simple Histogram-Based Capacitor Mismatch Calibration in SAR ADCs

A 15-Bit, 5 MSPS SAR ADC with On-Chip Digital Calibration

A 16-Bit 2.5-Ms/s SAR ADC with On-Chip Foreground Calibration

A Code-Pattern-driven Digital Background Calibration Technique for SAR ADCs

An 18-Bit 2MSPS SAR ADC with Double Passive Noise-Shaping Calibration

A Calibration Technique Based on Frequency-Domain Characteristics for Pipelined ADCs

Capacitor mismatch calibration for SAR ADCs based on comparator metastability detection

A statistics-based background capacitor mismatch calibration algorithm for SAR ADC

Capacitor Mismatch Calibration Method for SAR ADC with Minimum Area and Power Penalty

A capacitive mismatch calibration method for SAR ADCs based on TDC

A novel capacitor recombination calibration method applied to 18-bit SAR ADC

A 14-Bit 500-Ms/s Pipelined-SAR ADC in 28-Nm CMOS with Foreground and Background Calibration

A Calibration Scheme for a 800-Ms/s 14 Bit Pipelined ADC in 28-Nm CMOS

A 14-Bit Column-Parallel Two-Step SA ADC with Digital Calibration Based on Scaled References and Redundancy for CMOS Image Sensors

A Digital Background Calibration Scheme for Non-Linearity of SAR ADC Using Back-Propagation Algorithm

A Calibration Technique for SAR ADC Based on Code Density Test

An Improved Foreground Calibration Method for Capacitor Mismatch in NS-SAR ADC

Calibration for capacitor weight error of non-binary SAR ADC

Capacitor Recombination Algorithm Combined with LMS Algorithm in 16-Bit SAR ADC with Redundancy

A calibration technique for mismatch of capacitor arrays in A/D and D/A converters

An 18-Bit SAR ADC with Mixed DAC and Capacitive Recombination Calibration