Abstract:Plastic wastes are environmentally problematic and costly to treat, but they also represent a vast untapped resource for the renewable chemical and fuel production. Pyrolysis has received extensive attention in the treatment of plastic wastes because of its technical maturity. A sole polymer in the waste plastic is easy to recycle by any means of physical or chemical techniques. However, the majority of plastic in life are mixtures and they are hard to separate, which make pyrolysis of plastic complicated compared with pure plastic because of its difference in physical/chemical properties. This work focuses on the synergistic effect and its impact on chlorine removal from the pyrolysis of chlorinated plastic mixtures. The pyrolysis behavior of plastic mixtures was investigated in terms of thermogravimetric analysis, and the corresponding kinetics were analyzed according to the distributed activation energy model (DAEM). The results show that the synergistic effect existed in the pyrolysis of a plastic mixture of LLDPE, PP, and PVC, and the DAEM could well predict the kinetics behavior. The decomposition of LLDPE/PP mixtures occurred earlier than that of calculated ones. However, the synergistic effect weakened with the increase of LLDPE in the mixtures. As for the chlorine removal, the LLDPE and PP hindered the chlorine removal from PVC during the plastic mixture pyrolysis. A noticeable negative effect on dechlorination was observed after the introduction of LLDPE or PP. Besides, the chlorine-releasing temperature became higher during the pyrolysis of plastic mixtures ([LLDPE/PVC (1:1), PP/PVC (1:1), and LLDPE/PP/PVC (1:1:1)]. These results imply that the treatment of chlorinated plastic wastes was more difficult than that of PVC in thermal conversion. In other words, more attention should be paid to both the high-temperature chlorine corrosion and high-efficient chlorine removal in practical. These data are helpful for the treatment and thermal utilization of the yearly increased plastic wastes.

Hydrothermal Liquefaction of Polycarbonate (PC) Plastics in Sub-/Supercritical Water and Reaction Pathway Exploration

Highly Selective Preparation and Depolymerization of Chemically Recyclable Poly(cyclopentene Carbonate) Enabled by Organoboron Catalysts.

Hydrothermal Liquefaction of Plastics: a survey of the effect of reaction conditions on the reaction efficiency.

Experimental Investigation on Liquefaction of Plastic Waste to Oil in Supercritical Water.

Experimental Investigation on Gasification Characteristics of Polycarbonate (PC) Microplastics in Supercritical Water

Hydrothermal liquefaction of diverse plastics using water and seawater

Resource utilization of thermoplastics in supercritical water

Recycling of Phenol from Poly (1,4-Cyclohexylene Dimethylene Terephthalate) Using Subcritical Water from 260 to 340 °C

Degradation of Polycarbonate in Supercritical Ethanol

Experimental Investigation on Gasification Characteristics of Plastic Wastes in Supercritical Water

Experimental analysis on products distribution, characterization and mechanism of waste polypropylene (PP) and polyethylene terephthalate (PET) degradation in sub-/supercritical water

Process Analysis of Controllable Polycarbonate Depolymerization in Ethylene Glycol

Reactive Molecular Dynamics Simulations of Poly(Vinyl Alcohol) Gasification in Supercritical Carbon Dioxide

Exploring flotation separation of polycarbonate from multi-microplastic mixtures via experiment and numerical simulation

Modeling and Tracing of Polycarbonate (PC) Degradation in Soil Microcosm with a PC Microplastics Quantification Method Based on Pyrolysis GC-MS

Efficient Low-Temperature catalytic depolymerization of LLDPE into valuable compounds using H-ZSM-5 catalysts and water

Synergistic Effect and Chlorine-Release Behaviors During Co-pyrolysis of LLDPE, PP, and PVC

Co-gasification of Plastic Wastes and Soda Lignin in Supercritical Water

Sustainable recovery of monomers from PET and PC waste via thermocatalytic depolymerization for synthesis of polycarbonates and co-polycarbonates

Synthesis of polycarbonate in supercritical CO_2

Pyrolysis Characterization and Mechanism Studies of Different Structural Plastics: A Comparative Study at Optimal Temperatures