Failure Properties of Cubic Granite, Marble, and Sandstone Specimens under True Triaxial Stress

Kun Du,Chengzhi Yang,Rui Su,Ming Tao,Shaofeng Wang

DOI: https://doi.org/10.1016/j.ijrmms.2020.104309

IF: 6.849

2020-01-01

International Journal of Rock Mechanics and Mining Sciences

Abstract:Cubic specimens of granite, marble, and sandstone, with side lengths of 50 mm, were prepared in the laboratory. True triaxial compression tests were conducted on each rock type with minor principal stress (sigma(3)) magnitudes of 10, 20, 30, 50, and 100 MPa and the intermediate principal stress (sigma(2)) varying from sigma(2) = sigma(3) to sigma(2) = sigma(1) (where sigma(1) represents the major principal stress). The experimental results demonstrated that the failure strength, fracture dip angle, non-linear behavior and failure mode of these rocks under true triaxial conditions were affected by both sigma(2) and sigma(3), as well as by the rock lithology. When sigma(3) was kept constant and sigma(2) increased, failure strength showed an initial increase followed by a decrease, whereas the fracture dip angle increased monotonically. The non-linear behavior before the peak strength point of granite became more apparent by the increase of sigma(3), whereas sigma(2) had an opposite effect on the non-linear behavior of granite under high sigma(3) (e.g. 100 MPa). The non-linear behavior before the peak strength point was always found in marble and sandstone for all of the stress state conditions. Analyses of fracture dip angle and failure mode showed that when sigma(3) = 10, 20, and 30 MPa and sigma(2)/sigma(3). >= 5, 7.5, and 10, respectively, the failure mode of granite changed from shear to slabbing, whereas marble and sandstone always fractured in the shear direction. This study confirms that rocks may experience slabbing failure under true triaxial stress, and slabbing failure mode is likely to be induced in high-strength and brittle rocks under low sigma(3) with the stress ratio of sigma(2)/sigma(3) exceeding a particular threshold value.