Abstract:Cu/SiO2 catalyst prepared by the ammonia-evaporation (AE) method is the potential preferred catalyst for hydrogenation of dimethyl oxalate (DMO) to ethylene glycol (EG). Although significant advancements have been obtained in the confirmation and influence factors of active species in the hydrogenation process, the relationship between the catalytic activity and the sensitive factors in the preparation or pretreatment process of the catalyst is still uncertain. In this paper, Cu/ZSM-5 catalysts for DMO hydrogenation to EG were prepared by the AE method using ZSM-5 molecular sieve with high silicon-alumina ratio (1500) as a support. The ZSM-5 support was pretreated by drying at 393 K for different hours and it was found that the surface hydroxyl group of the support had significant influence on the structure and catalytic hydrogenation performance of the prepared Cu/ZSM-5 catalyst. The distribution of surface hydroxyl groups could be significantly changed by pre-drying the carrier, which further resulted in the change of the copper dispersion and surface properties of subsequent copper-supported catalysts. With the decrease of hydroxyl content on the surface of the ZSM-5 support, the prepared reduced Cu/ZSM-5 catalyst possessed smaller Cu0 particles size, higher copper dispersion, higher surface area of Cu0 and Cu+ species, but weakened surface acidity of the catalyst, which resulted in the great improvement of the catalytic activity. The DMO conversion and EG selectivity could reach 100% and 93% even under the low reaction temperature at 448 K over the Cu/ZSM-5-24 catalyst (based on the ZSM-5 support pretreated by drying for 24 h). In addition, the catalytic activity did not show obvious change after 300 h of reaction, probably due to the low temperature reaction and suitable surface properties of the catalyst.Graphical Abstract

Cu Active Sites Confined in MgAl Layered Double Hydroxide for Hydrogenation of Dimethyl Oxalate to Ethanol

Enhanced catalytic stability of Cu-based catalyst for dimethyl oxalate hydrogenation

Synthesis of Methanol over Highly Dispersed Cu-Fe Based Catalysts Derived from Layered Double Hydroxides.

Perspectives on the Active Sites and Catalyst Design for the Hydrogenation of Dimethyl Oxalate

Synthesis of a high surface area and highly dispersed Cu-O-Si complex oxide used for the low-temperature hydrogenation of dimethyl oxalate to ethylene glycol

Preparation and modification of Cu/SiO2 catalyst for hydrogenation of dimethyl oxalate to ethyl glycol

Ultra-stable Cu-based catalyst for dimethyl oxalate hydrogenation to ethylene glycol

Role of the Cu dopant in the textural and catalytic features of the Co/ZnO catalyst for dimethyl oxalate selective hydrogenation

Superior silicon-free Cu catalyst for dimethyl oxalate hydrogenation: Exploring interaction between Cu and pyridinic-N-rich ultrathin carbon

Mg–Al Mixed Oxide Derived from Hydrotalcites Prepared Using the Solvent-Free Method: A Stable Acid–Base Bifunctional Catalyst for Continuous-Flow Transesterification of Dimethyl Carbonate and Ethanol

Highly Active and Selective Copper-Containing Hms Catalyst in the Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Enhanced Catalytic Performance for SiO2–TiO2 Binary Oxide Supported Cu-based Catalyst in the Hydrogenation of Dimethyloxalate

The influence of Mg/Al molar ratio on the performance of CuMgAl-x catalysts for CO2 hydrogenation to methanol

Highly stable Cu catalyst embedded in N-doped carbon microsphere for hydrogenation of dimethyl oxalate to methyl glycolate

Efficient Tuning of Surface Copper Species of Cu/SiO2 Catalyst for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Effect of Surface Hydroxyl Content of Support on the Activity of Cu/ZSM-5 Catalyst for Low-Temperature Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Synthesis of a Cu@ZnO1-x/Al2O3 Catalyst with High-Density ZnO1-x-Cu Interfacial Sites for Enhanced CO2 Hydrogenation to Methanol

Identification of Synergistic Actions Between Cu0 and Cu+ Sites in Hydrogenation of Dimethyl Oxalate from Microkinetic Analysis

Interface-enhanced Catalytic Performance of TiO2-supported Cu and Au for Dimethyl Oxalate Hydrogenation: A Comparative Microkinetic Analysis

Insight to structure-activity relationship of non-stoichiometric CuMgAl spinel catalysts for CO hydrogenation to dimethyl ether: Effect of MgO doping amount

The facile preparation of Cu–Zn–Al oxide composite catalysts with high stability and performance for the production of dimethyl ether using modified aluminum alkoxide