Abstract:Sampling-based PLLs have become a new research trend due to the possibility of removing the frequency divider (FDIV) from the feedback path, where the FDIV increases the contribution of in-band noise by the factor of dividing ratio square (N2). Between two possible sampling methods, sub-sampling and reference-sampling, the latter provides a relatively wide locking range, as the slower input reference signal is sampled with the faster VCO output signal. However, removal of FDIV makes the PLL not feasible to implement fractional-N operation based on varying divider ratios through random sequence generators, such as a Delta-Sigma-Modulator (DSM). To address the above design challenges, we propose a reference-sampling-based calibration-free fractional-N PLL (RSFPLL) with a phase-interpolator-linked sampling clock generator (PSCG). The proposed RSFPLL achieves fractional-N operations through phase-interpolator (PI)-based multi-phase generation instead of a typical frequency divider or digital-to-time converter (DTC). In addition, to alleviate the power burden arising from VCO-rated sampling, a flexible mask window generation method has been used that only passes a few sampling clocks near the point of interest. The prototype PLL system is designed with a 65 nm CMOS process with a chip size of 0.42 mm2. It achieves 322 fs rms jitter, -240.7 dB figure-of-merit (FoM), and -44.06 dBc fractional spurs with 8.17 mW power consumption.

PI-Based Synchronous Reference Frame Frequency-Locked Loop

A Novel Synchronous Reference Frame Frequency-Locked Loop.

Multi-chip Phase Synchronization Circuit of Fractional-N PLL

Implementation of an Intelligent Digital Phase-Locked Loop Based on FPGA

High-Order Frequency-Locked Loop: General Modeling and Design

Three-phase digital phase-locked loop based on synchronous reference frame

Polar-Frame-Based Modeling and Small-Signal Stability Analysis of DDSRF-PLL: On the Different Implementation Structures Effect

A Digital Optical Phase-Locked Loop Based on Field Programmable Gate Array and Its Applications

A Novel Single Phase Synchronous Reference Frame Phase-Locked Loop with A Constant Zero Orthogonal Component

A novel single-phase locked loop algorithm based on synchronous reference frame

A Hybrid Frequency/phase-Locked Loop for Versatile Clock Generation with Wide Reference Frequency Range

Digital PLL with Fixed Number of Sampling Points for Repetitive Control Algorithm

A Fixed-Length Transfer Delay Based Adaptive Frequency-Locked Loop for Single-Phase Systems

A 5-Bit Phase-Interpolator-Based Fractional-N Frequency Divider For Digital Phase-Locked Loops

A 2.6ghz ΔΣ Fractional-N Bang-Bang PLL with FIR-Embedded Injection-Locking Phase-Domain Low-Pass Filter

A DTC-Free Fractional-N BBPLL with FIR-Embedded Injection-Locked-Oscillator-Based Phase-Domain Lowpass Filter

A Reference-Sampling Based Calibration-Free Fractional-N PLL with a PI-Linked Sampling Clock Generator

FPGA based ratio changeable all digital phase-locked-loop

The FPGA implement of ADPLL without retimed clock

A Novel Three-Phase Software Phase-Locked Loop Based on Frequency-Locked Loop and Initial Phase Angle Detection Phase-Locked Loop.

A New Synchronous Frame Single-Phase PLL Algorithm with a Decoupling Network