Novel Bending Sensor Based on a Solution-Processed Cu 2 O Film with High Resolution Covering a Wide Curvature Range

Ryosuke Nitta,Ryo Taguchi,Yuta Kubota,Tetsuo Kishi,Atsushi Shishido,Nobuhiro Matsushita
DOI: https://doi.org/10.1021/acsomega.1c04279
IF: 4.1
2021-11-08
ACS Omega
Abstract:A Cu<sub>2</sub>O film is prepared on a flexible polyethylene terephthalate substrate for a bending sensor using the spin-spray method, a facile and low-environmental-load solution process. The Cu<sub>2</sub>O bending sensor shows high sensitivity and high resolution not only over a wide range of curvatures (0 &lt; κ &lt; 0.21 mm<sup>-1</sup>) but also for very small curvature changes (Δκ = ∼ 0.03 mm<sup>-1</sup>). The bending response of the sensor exhibited a curvature change of high linearity with a good gauge factor (18.2) owing to the grain-boundary resistance and piezoresistive effects of the fabricated Cu<sub>2</sub>O film. In addition, the sensor possesses good repeatability, stability, and long-term (&gt;30 days) and mechanical fatigue durability (1000 bending-release cycles). The sensor is capable of detailed monitoring of large- and small-scale human motions, such as finger bending, wrist bending, nodding, mouth opening/closing, and swallowing. In addition, excellent stability and repeatability of the monitoring performance is observed over a wide range of motion angles and speeds. All of these results demonstrate the potential of the flexible bending sensor based on the Cu<sub>2</sub>O film as a candidate for healthcare monitoring and wearable electronics.
chemistry, multidisciplinary
What problem does this paper attempt to address?