Abstract:Large-displacement shear appears between pile shaft and its surrounding soil during the penetration process, and cyclic shear is the typical feature in subsequent service load condition. In this paper, a series of interface shear tests have been conducted to investigate the sand-steel interface behaviors under large-displacement and cyclic shear. Three types of particles (quartz sand, carbonate sand and steel bead) and two normal boundary conditions (constant normal load, CNL; constant normal stiffness, CNS) were used in these tests. To simulate the large displacement shear process for monotonic installed pile, the large-displacement shear is performed using monotonic shear method. It is found that under the large-displacement shear with CNL condition, the quartz sand and carbonate sand show different breakage degrees and modes. Obvious particle breakage changes both the particle gradation and sample densification, which are the main reasons for the increase of interface friction angle. While for the cyclic shear with CNS condition, the interface strength shows a quick degradation feature, which is mainly affected by the initial shape of particles. It is also found that the previous interface shear plays a key role in this kind of degradation. When the shear displacement is small, the degradation is promoted with only a small amount of sand breakage. But if the sand breakage is significant under the large-displacement shear, abundant broken fine particles fill into the void and make the sand sample much denser. So, the degradation trend of interface strength will be suppressed. It is suggested that the previous large-displacement shear process for displacement pile should be adequately considered in the design.

Large-Scale Test Study on the Three-Dimensional Behavior of the Gravel–Concrete Interface of a CFR Dam

Numerical modeling of soil–structure interface of a concrete-faced rockfill dam

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Experimental Study on Direct Shear Performance of Concrete-Concrete Interface of Prefabricated Structure Sleeve Grouting Connection

Three-dimensional Monotonic and Cyclic Behavior of a Gravel–steel Interface from Large-Scale Simple-Shear Tests

Three-dimensional refined analysis of seismic cracking and anti-seismic measures performance of concrete face slab in CFRDs

Large-scale direct shear test investigation of the 3D behavior of a gravel-structure interfaces

The simulation of high compressive stress and extrusion phenomenon for concrete face slabs in CFRDs under strong seismic loads

Time-dependent Deformation in High Concrete-Faced Rockfill Dam and Separation Between Concrete Face Slab and Cushion Layer

Construction of Concrete-Faced Rockfill Dams with Weak Rocks

Shear Coupling Effect Of Monotonic And Cyclic Behavior Of The Interface Between Steel And Gravel

Scaling Effect on the Mechanical Behavior of the Interface Between Coarse-Grained Materials and a Structure

A parabolic model and an iterative algorithm for the slab-cushion interface and the application in simulating the dynamic separation between the face slabs and cushion layer

Dynamic Centrifuge Experimental Study on Dam–Reservoir Interaction in Concrete-Face Rockfill Dams under Earthquake Loading

Three-Dimensional Direct-Shear Behaviors of a Gravel–Structure Interface

Three‐dimensional Numerical Analysis of Concrete‐faced Rockfill Dam Using Dual‐mortar Finite Element Method with Mixed Tangential Contact Constraints

Influence of Creeping on Separation Between Concrete Slab and Cushion Layer in High Concrete Face Rock-Fill Dam

Experimental study on 3D monotonic behavior of a gravel-structure interface considering initial shear stress

Comparative Study on Interface Elements, Thin-Layer Elements, and Contact Analysis Methods in the Analysis of High Concrete-Faced Rockfill Dams

Mechanisms and simulation methods for extrusion damage of concrete faces of high concrete-faced rockfill dams

Influence of shear paths on 3D cyclic behaviors of the gravel-structure interface