Abstract:The scale effect is an unavoidable problem in the laboratory test of coarse-grained materials. By combining the self-developed cellular automaton program with laboratory experiments, a method of simulating the triaxial test of coarse-grained materials was proposed in this paper, and a triaxial test numerical specimen that can characterize the discontinuous, nonuniform, and heterogeneous characteristics of bulk geotechnical materials was established. The parallel grading method was adopted to create six grading curves for numerical simulation based on one in situ grading curve. The failure process and the scale effect on the strength and deformation of coarse-grained materials were analyzed and discussed. The results showed that under the same confining pressure, the peak stress and initial deformation modulus E i increased with the increase of the maximum particle size d max , while the degree of shear shrinkage and Poisson’s ration υ decreased. As the confining pressure increased, the scale effect of coarse-grained materials would be magnified. If particle breakage and migration were assumed to be neglected, the internal friction angle φ and d max would be roughly proportional, the cohesive force c fluctuated with the increase of d max , and the empirical relations between d max and c and φ were established, respectively, which provides a reference for estimating the actual shear strength parameters of coarse-grained materials on-site. The research results can provide a way of thinking for the study of the scale effect of coarse-grained materials and also have certain reference significance for inferring the strength parameters of the original-graded coarse-grained materials.

Scaling Effect on the Mechanical Behavior of the Interface Between Coarse-Grained Materials and a Structure

The Scale Effect of Coarse-Grained Materials by Triaxial Test Simulation

Study on scale effect and particle crushing characteristics of continuously graded coarse-grained soil

Experimental Study on Mechanical Behavior of Interface Between Two Granular Materials

Mechanical Characteristics for Interfaces Between Granular Materials

Particle size effects on coarse soil-geogrid interface response in cyclic and post-cyclic direct shear tests

Large-Scale Test Study on the Three-Dimensional Behavior of the Gravel–Concrete Interface of a CFR Dam

Influence of soil particle size on monotonic and cyclic direct shear behaviors of geogrid-soil interface

Monotonic and Cyclic Behaviors of Coarse-Grained Soil-Structure Interface Using Large-Scale Simple Shear Device

Effect of aperture ratio on the cyclic shear behaviour of aggregate-geogrid interfaces

Test Study on Behavior of Interface Between Structure and Coarse Grained

Experimental Study on Monotonic Behavior of Interface Between Soil and Structure

Micromechanical Investigation of Suffusion and Its Consequence in Gap-Graded Granular Soil at the Opening of Underground Structures Using the Coupled CFD-DEM Method

Experimental Study on Direct Shear Performance of Concrete-Concrete Interface of Prefabricated Structure Sleeve Grouting Connection

Three-dimensional Monotonic and Cyclic Behavior of a Gravel–steel Interface from Large-Scale Simple-Shear Tests

Experimental research on reinforcement-soil interface stiffness and damping ratio under cyclic shearing

Study on the scale effect and meso-macro mechanism of soil-rock mixture in the whole process ofthe deformation and failure View project

Large-scale direct shear test investigation of the 3D behavior of a gravel-structure interfaces

Experimental Study on the Effect of Coarse Grain Content on the Dilatancy and Particle Breakage Characteristics of Coarse-Grained Soils

Investigation on the cyclic shear properties of steel-crushed red mudstone particles interface

Influence of calcareous nodules content on scaling effect in shear strength of cohesive soil containing calcareous nodules