A Comprehensive Comparison Study: the Impacts of Gasifying Agents and Parameters on Chinese Herb Medicine Residue Gasification

Guo Qianqian,Li Jian,Guo Xiang,Tianjin Key Lab of BiomassWastes Utilization,Hou Li’an
DOI: https://doi.org/10.1007/s12649-020-01037-x
2020-01-01
Waste and Biomass Valorization
Abstract:Traditional treatments of Chinese herb medicine residue (CHMR) inevitably cause secondary pollution and hardly remove the pesticide in it. Therefore, high-temperature treatment might be promising to achieve the reduction and resource utilization of CHMR. Based on this, the effects of essential parameters including temperature, equivalent ratio (ER), oxygen concentration and steam to biomass ratio (S/B ratio) were systematically and synthetically analyzed to explore the method and mechanism of improving gasification characteristics. Increasing temperature would promote endothermic reactions thus enhancing the gasification process. The optimal ER of air, oxygen-enriched air and oxygen-enriched air steam gasification are the same, 0.26. Higher O2 concentration would promote oxidation reaction thus increasing the temperature in gasifier and being conducive to the generation of CO and H2, while excess O2 would react with CO and H2. The optimal O2 concentration in oxygen-enriched air and oxygen-enriched air steam gasification were 40 vol% and 50 vol%, respectively. It might be caused by that more O2 was needed to offset the temperature reduction caused by steam addition. Supplying proper steam (S/B = 1.0 and 1.6 for oxygen-enriched air and oxygen-enriched air steam gasification, respectively) could promote the Primary water–gas ad Steam reforming reaction thus increasing the CO and H2 yields. However, excessive steam could reduce reaction temperature and be not conducive to gasification. Moreover, grey relational analysis was introduced to solve multi-attribute decision making issues and determine the influence levels of these parameters thus guiding CHMR gasification technology. These parameters followed the order of S/B ratio > O2 concentration > temperature > ER.
What problem does this paper attempt to address?