The Degradation of Equivalent Elastic Modulus of Steel Wire Ropes under Long-Term Loading
Man-yu Deng,Xing-Fei Yuan,Yue Feng
DOI: https://doi.org/10.1016/j.conbuildmat.2024.138553
IF: 7.4
2024-01-01
Construction and Building Materials
Abstract:Steel wire ropes will creep under long-term loading, resulting in the deterioration of tensile structure performance. From the perspective of materials science, the creep of steel ropes can be understood as the degradation of their equivalent elastic modulus over time, and there are currently no methods or formulas to quantify this degradation. The main purpose of this paper is to propose a general formula for calculating the equivalent modulus degradation of wire ropes, which will facilitate the assessment of performance variations in tensile structures during service. In this study, an experiment on the degradation of the equivalent elastic modulus of steel wire ropes under long-term loading was conducted. In the experiment, measurements were taken using two types of small-diameter steel wire ropes at three stress levels, with data collected over 20,000 h. The results showed that the degradation of the equivalent elastic modulus transitions from rapid to gradual over time and can be divided into three periods. A universal calculation formula was proposed to conveniently express this degradation law, derived from viscoelastic theory with specific parameters obtained through data fitting. To extend the formula's applicability to a wider range of diameters and stress levels, ANSYS was utilized to develop refined models of steel wire ropes and the parameters were determined by the experimental results. After comparison, it was observed that the differences between the calculated values of the formula and the simulated values of the model were relatively small for small diameters, verifying the accuracy of the proposed formula. However, for larger diameters, significant differences were observed in the early phase of the second period. Consequently, an additional experiment was conducted on a wire rope with a diameter of 18 mm to verify the feasibility of the formula for large diameters. The results showed that the measured values closely matched the simulated values from the model. Based on the simulated values, a revised formula was proposed for largediameter ropes. The two proposed calculation formulas can be used to quickly estimate the degradation of the equivalent elastic modulus of steel wire ropes. Numerical results further demonstrated that due to the degradation of the equivalent elastic modulus of wire ropes, the mechanical performance of the structure significantly deteriorates over time, offering a valuable reference for structural health monitoring and tensile structure evaluation.