Abstract:A novel laser powder bed fusion (LPBF) process utilizing a special double-pulse format was previously proposed. In this process, typically two different types of laser pulses are fired alternatively in time: the low-intensity "sintering laser pulses" intended to melt and coalesce particles, followed by the high-intensity "pressing laser pulse(s)" intended to induce plasma to generate high pressure onto the powder bed to suppress balling and enhance the density of the sintered material. Laser-induced plasma plays a key role in the novel double-pulse LPBF process, but has not been studied sufficiently. Some critical questions remain to be better answered, such as: what is the minimum plasma-induced pressure needed to effectively suppress balling and how do the "sintering pulses" influence the plasma evolution? This paper reports a model-experiment integrative study of the plasma in DP-LMS, which is seldom reported in a paper in literature to the authors' knowledge. The plasma evolution is observed in-situ with a high temporal resolution using an intensified CCD (ICCD) camera. The optical emission spectrum (OES) of the plasma is measured and the plasma temperature is deduced from the OES. A physics-based model for the plasma is developed by combining multiple modules. Under the investigated conditions, the model predictions show acceptable agreements with the measured plasma temperature and top front propagation. Utilizing the model, it has been found that under the conditions studied, the minimum plasma-induced pressure required to effectively suppress balling is approximately the pressure making the Weber number exceed ~1 for the approximately analogized process of a droplet impacting a solid surface. The effect of the "sintering pulses" also influences the evolution of the plasma and obviously increase the plasma-induced pressure on the powder bed surface.

Dynamic Simulation of Laser-produced Plasma under Plate Constraint

Self-compression and splitting of laser pulse in plasmas

Effects Of Laser And Plasma Parameters On Shock Wave Generation And Acceleration Of Protons

Effect of External Constraint on the Characteristics and Behavior of the Plasma Plume During High-Power CO 2 Laser Welding

Model Study on Laser Interaction with Near-Critical Density Plasma

Characteristics of Plasma Plume and Effect Mechanism of Lateral Restraint During High Power Co2 Laser Welding Process

A study of one-dimensional colliding laser-produced plasmas through modeling and experimentation

Simulation of Laser Interaction with Ablative Plasma and Hydrodynamic Behavior of Laser Supported Plasma

A Study of Arc Plasma Energy Deposition Flow Control on Blunt-Headed Protuberance Induced STBLI

Some Nonlinear Phenomena in a Preformed Underdense Plasma

The Spatio-Temporal Evolution of Shock Wave Pressure Induced by Laser: Effects of Laser Parameters and Confinement Layer

Transient thermoelastic response analysis of porous composite structures ablated by the ultrashort pulse laser considering absorption mechanisms of plasma plume

Experimental Study of the Behavior of Two Laser Produced Plasmas in Air

Enabling direct kinetic simulation of dense plasma plume expansion for laser ablation plasma thrusters

Effects of Ponderomotive Forces and Space-Charge Field on Laser Plasma Hydrodynamics

Plasma Evolution in Laser Powder Bed Fusion using a Double Pulse Format: Time-resolved Measurements and Physics-based Modeling

Two-Dimensional Hydrodynamic Characteristics of X-Ray Lasers Plasmas

Theoretical and Experimental Study on Laser Compound Forming of Plate

Particle Simulation and Electron Heating Effects in Plasmas Produced by Laser Pulse

Characteristic and Impact of Kinetic Effects at Interfaces of Inertial Confinement Fusion Hohlraums

Experiments and Numerical Simulations on Laser Welding Deformation of Thin Plate Considering Constraint Clamp