Abstract:A loop heat pipe is a passive heat transfer device with strong robustness, high efficiency, and good performance, and has been widely utilized in numerous thermal control systems. Herein, an intensive study of a flat-plate evaporator LHP from the perspective of experiment and simulation is presented. First, the vapor leakage problem, which was a common issue for most LHP systems, was solved by filling the assembly clearance with epoxy glue, and a flat-plate LHP system was fabricated to verify its operating performance. Test results indicated that the loop stably performed under various working conditions without temperature oscillation. The maximum heat flux was 11.25 W/cm2 and the minimum thermal resistance was 0.1340 degrees C/W. The heater surface temperature remained low except during the dry-out state in wick at the maximum heat load condition where a sharp increase was observed, and temperature hysteresis occurred during variable heat load tests owing to the transport lag in long liquid line. Based on the above experiment, an efficient 3-D CFD computational model was built to simulate the heat and mass transfer process in a flat-plate evaporator by the Volume of Fluid method. In addition, the flow regime with two-phase distribution at the scale of the entire evaporator was calculated by considering the structure effect. Boundary conditions were derived from the experiment and the mass flow rate at the evaporator inlet was deduced from the heat leakage effect in liquid line. Calculation results demonstrated that four symmetric vortices developed inside the compensation chamber and generated uneven subcooled liquid infiltration in wick, further leading to a slight offset of high-temperature zone to the evaporator inlet side. Parameter analysis indicated that the ribs conducted 84 % of the heat conduction using thermal paths formed between the heater surface and liquid-vapor interface. The vapor volume percentage in the vapor collector was above 80 %, and increasing the heat load reduced the vapor volume in wick as well as the percentage of heat adsorbed during evaporation. Experimental comparison illustrated that the model exhibited a high accuracy with an error less than 10.29 %.

Experimental Study of Heat Transfer Capacity for Loop Heat Pipe with Flat Disk Evaporator

Experimental investigation of loop heat pipe with flat evaporator using biporous wick

Simulation of Steady-State Operation of an Ejector-Assisted Loop Heat Pipe with a Flat Evaporator for Application in Electronic Cooling

Simulation of heat and mass transfer process in a flat-plate loop heat pipe and experimental comparison

Experimental Investigation on Stainless-Steel-Ammonia Loop Heat Pipe With Flat Evaporator

Experimental Study of an Ammonia Loop Heat Pipe with a Flat Plate Evaporator

Experimental study on thermal performance of loop heat pipe with a composite-material evaporator for cooling of electronics

Experimental Study on Loop Heat Pipe with Two-Wick Flat Evaporator

A Study on Thermal Performance of a Pump-Assisted Loop Heat Pipe with Ammonia As Working Fluid

Experimental Investigation of Loop Heat Pipe with a Large Squared Evaporator for Multi-Heat Sources Cooling

Thermal Performance of an Ammonia Loop Heat Pipe Using a Rectangular Evaporator with Liquid-Guiding Channels

Experimental study of the loop heat pipe with a flat disk-shaped evaporator

Experimental investigation of a miniature loop heat pipe with eccentric evaporator for cooling electronics

Numerical study of heat distribution in a disk-shaped evaporator of a loop heat pipe at steady-state operation mode

Experimental study on a rectangular evaporator loop heat pipe with a phase-change material heat sink

Experimental Study on the Thermal Performance of an Ammonia Loop Heat Pipe Using a Rectangular Evaporator with Longitudinal Replenishment

Investigation of the Thermal Characteristics of a Flat Bifacial Evaporator Loop Heat Pipe

Experimental Investigation on Temperature Oscillation in a Miniature Loop Heat Pipe with Flat Evaporator

Design and Experimental Validation of a High Capacity Loop Heat Pipe for Avionics Cooling

Experimental Investigation on the Heat Transfer Characteristics of Loop Heat Pipe with Carbon Spheres Modified Nickel Wick

Experimental Investigation of Loop Heat Pipe with a Large Squared Evaporator for Cooling Electronics