Abstract:Bridge vehicle-load and damage-condition information plays a vital role in the structural analysis and assessment of bridges. This information can be derived from bridge responses (such as displacement, acceleration, and strains). Most existing bridge damage and load identification methods are based on different measurements from both the bridge damage and load subsystems (different sensors and methods) in the literature. Accordingly, more sensors and measuring activities are required; therefore, the costs associated with structural health monitoring tend to rise. This paper proposes a new method for the synchronous identification of damage and vehicle loads on simply supported bridges, which uses just one set of long-gauge fiber Bragg grating (FBG) sensors and reduces the use of sensing devices, sensors, and costs. In the proposed method, the correlations among the peak values of static macrostrain curves, bending stiffness of bridge cross sections, and vehicle loads are established based on the macrostrain influence line theory. A numerical case study of a 30-m simply supported bridge, subject to moving vehicles, is performed to preliminarily validate the effectiveness of the proposed method. In this case, the damage identification error is below 6%, and the load identification error is less than 4%. In addition, a laboratory experiment including a model bridge and car is conducted to further examine the feasibility of this method in engineering practice, and the results show that the model bridge damage and load can be identified synchronously with good accuracies. (C) 2019 American Society of Civil Engineers.

Multi-Cross-Reference Method for Highway-Bridge Damage Identification Based on Long-Gauge Fiber Bragg-Grating Sensors

Reference-free damage identification method for highway continuous girder bridges based on long-gauge fibre Bragg grating strain sensors

Synchronous Identification of Damage and Vehicle Load on Simply Supported Bridges Based on Long-Gauge Fiber Bragg Grating Sensors

Real-time strain monitoring and control of urban bridge cluster monitoring system with FBG sensor

A rapid output-only damage detection method for highway bridges under a moving vehicle using long-gauge strain sensing and the fractal dimension

Multi-scale finite element model updating of highway bridge based on long-gauge strain response

Damage Identification Method for Continuous Girder Bridges Based on Spatially-Distributed Long-Gauge Strain Sensing under Moving Loads

Damage detection of highway bridges based on long-gauge strain response under stochastic traffic flow

Bridge Assessment And Health Monitoring With Distributed Long-Gauge Fbg Sensors

Multi-channel fiber optical sensing system for urban bridge cluster health monitoring

Experimental Study on Damage Detection of Railway Turnouts Based on Characteristics of FBG Reflective Spectra

Development and Application of Temperature Measurement System for Urban Bridges

Simultaneous Identification Method of Damage and Vehicle Parameters on Bridges Utilizing Long-Gauge Strain Influence Line under Moving Vehicle Loads

DYNAMIC BEHAVIOR OF THREE-SPAN CONTINOUS STONE ARCH BRIDGE MEASURED BY FIBER BRAGG GRATING (FBG) SENSORS

Stiffness Monitoring and Damage Assessment of Bridges under Moving Vehicular Loads Using Spatially-Distributed Optical Fiber Sensors

Structural health monitoring of a steel stringer bridge with area sensing

Effective LiDAR Damage Detection:Comparing Two Detection Algorithms

Detection of interface damage of composite structure using FBG sensing

Strain-Based Damage-Assessment Method for Bridges under Moving Vehicular Loads Using Long-Gauge Strain Sensing

Damage Detection and Sensor Placement Design for Two Highway Bridges

Local Health Monitoring of Sifangtai Bridge Using Fiber Bragg Grating Sensors