Abstract:In general, there are three kinds of common metal flexible couplings, such as diaphragm coupling, disc coupling and gear coupling. Gear couplings, compared with diaphragm couplings and disc couplings, usually have a little ability in compensating misalignments. Diaphragm couplings have nice compensatory ability in radial, angular and axial directions, especially muti-diaphragm couplings have better compensatory ability than disc couplings. Diaphragm couplings are also suitable for higher rotating speed than disc couplings. They are high technology products, are widely used in micro gas turbine. Joint way of a diaphragm coupling with a shaft usually uses bolts and interference fit. In this article, a flexible diaphragm coupling assembled by interference fit was taken as research object. By comparing three kinds of interference assembly forms of the coupling, a most reasonable form was chosen and its axial compensatory ability was treated as main research content. An idea that "established process of balances is the varied process of misalignment magnitude" was presented. Combining the idea and the characters of interference fit, new boundary conditions were confirmed via bringing assumed shearing forces, and then the physical model was established based on the new boundary conditions mentioned above. Two-step method, based on the physical model, was presented to solve the axial compensatory magnitude. Meanwhile centrifugal stress and torsional shearing stress of diaphragms of the coupling were also considered in the process of calculation. Finally an example was done to support the method. Some important conclusions were acquired by calculating, and they are significant for design of the flexible diaphragm couplings.

Test Mass Alignment Using Overlapped-Flexure Hinge in NIM-2 Joule Balance

Modeling and Design of an Overlapped-Flexure Hinge for Joule Balance

Modeling and design of a two-axis elliptical notch flexure hinge

Automatic alignment technique for the suspended coil in the joule balance

An Improved Analytical Model of a Thrust Stand with a Flexure Hinge Structure Considering Stiffness Drift and Rotation Center Offset

Concentricity Alignment Between Electromagnet Yoke and Suspended Coil in NIM-2

Development and Application of a Novel Four Components Plate Type Hinge Moment Balance

Application Study and Performance Testing of Cross-spring Flexible Hooke Hinge in Static Balancing Instrument

The Recent Research on the NIM-2 Joule Balance

Study on Compensatory Magnitude of Axial Misalignment for Flexible Couplings Assembled by Interference Fit

Design of Flexure Hinges in an H-Drive Precision Stage with a Large Span

The Interaction Between the Magnetized Coil-Suspension System and the Compensation Coil in the Joule Balance

Improvements of the NIM-2 Joule Balance Since 2020

A Novel Triple-Actuator Magnetic Suspension Balance System With Enhanced Load and Stability

Force Transmission of Flexure-Based Leverage Mechanism for Static Unbalance Measuring System under Self-Gravity Effect

A Parasitic Displacement Measurement System for Suspended Coil in Joule Balance

A novel bridge-type compliant displacement amplification mechanism under compound loads based on the topology optimisation of flexure hinge and its application in micro-force sensing

Analysis of balance beam deformation in the inertial mass measurement experiment

Theoretical Modeling and Experimental Verification of Elliptical Hyperbolic Hybrid Flexure Hinges

Multi-objective Optimization of Flexure Hinge Mechanism Considering Thermal–mechanical Coupling Deformation and Natural Frequency

The Progress of Joule Balance