Abstract:BACKGROUND:Recently, health care and disease prevention are more and more important in people's daily life. Human body communication (HBC) is an emerging short distance wireless communication mode, which is quite suitable for the communication between the wearable human health care equipment. However, most research on HBC mainly focuses on the electromagnetic model and the circuit model of equivalent human and the in vivo experiment is based on the commercial equipment.OBJECTIVE:The aim of this paper is to design a circuit device for measuring the attenuation of the human body channel based on a floating-ground-electrode method.METHODS:This paper proposed a new floating-ground-electrode method so as to solve problems of power and high frequencies interference and impedance matching. A circuit module, including signal generator, analog frontend circuit and MCU, was designed to initially replace the spectrum analyzer to measure the attenuation of the human body channel. The floating-ground-electrode added to the receiving end of the human body channel was connected to the ground of the analog frontend circuit, forming an equal potential circuit. The three-electrodes of the receiving terminal can act as a differential probe, since one electrode is connected to the ground and the other two electrodes achieved signal input and output respectively.RESULTS:The results showed that the experimental data of channel attenuation were similar to the measured value of the spectrum analyzer. The maximum absolute error was 1.148 dB and the relative error was 3.55%. In addition, different sizes of the floating-ground-electrode cannot affect the attenuation path of human body channels. Moreover, the common mode rejection ratio (CMRR) was approximated to the value of the commercial differential probe.CONCLUSION:This paper proposed a new floating-ground-electrode method for measuring the attenuation of the human body channel. It could provide the possibility for the dynamic measurement of attenuation and take the place of the spectrum analyzer and make the process of experiments simple and efficient.

A Differential Analog Receiver Front-End for Galvanic-Coupled Human Body Communication

A receiver analog front-end for body sensor network

Study on Signal Transmission Mechanism and Characteristic of Human Body Communication

An Analog Front-End with Automatic Gain Control for Galvanic-Coupled Human Body Communication

A Dual Mode Input Wideband Receiving Front End for Human Body Communication

Differential Isolation Integrated Circuit Design in Galvanic-Coupled Human Body Communication

Analysis of Wave Propagation on Human Body Based on Stratified Media Model

Design of a Floating-Ground-electrode Circuit for Measuring Attenuation of the Human Body Channel.

Design and feasibility study of human body communication transceiver based on FDM

A Transceiver Designed for Intra-body Communication of Body Area Networks

An Investigation On Phase Characteristics Of Galvanic Coupling Human Body Communication

A Novel Low-Power Compact WBS Human Body Channel Receiver for Wearable Vital Signal Sensing Application in Wireless Body-Area Network

Wearable Vital Signal Monitoring Prototype Based on Capacitive Body Channel Communication

Design and Implementation of Galvanic Coupling Intra-Body Communication Transceivers Using Differential Phase Shift Keying.

Initial Investigation of Channel Capacity for Galvanic Coupling Human Body Communication

Comprehensive measurements on body channel characteristics of Human Body Communication

Measurement system with experiments for galvanic coupling type intra-body communication.

Research on Human Body Communication Channel Characteristics

A 2.4‐mw Interference‐resilient Receiver Front End with Series N‐path Filter–based Balun for Body Channel Communication

Implant-to-Wearable Communication through the Human Body: Exploring the Effects of Encapsulated Capacitive and Galvanic Transmitters

A 6.3pJ/b 30Mbps -30dB SIR-tolerant Broadband Interference-Robust Human Body Communication Transceiver using Time Domain Signal-Interference Separation