Abstract:Constructing hetero-junction on TiO2 is an effective way to overcome the fast charge recombination and slow charge transfer kinetics, but how to design the junction is still a significant challenge in photo-electrochemical (PEC) water splitting. In this study, a considerable improvement in PEC performance for TiO2 nanotubes was achieved following the introduction of a ternary hetero-junction through depositing ZnIn2S4 (ZIS) and Zn0.6Ca0.4In2S4 (ZCIS) in sequence via a facile hydrothermal method (TiO2/ZIS/ZCIS). The optimized photo-anode exhibited a photocurrent density of 1.07 mA cm(-2) at 1.23 V vs. reversible hydrogen electrode (RHE), to be 3.96 and 1.25 times enhanced compared to that of TiO2 and TiO2/ZIS, respectively. Meanwhile, the incident photon-to-current conversion efficiency (IPCE) and applied bias photon-to-current efficiency (ABPE) of TiO2/ZIS/ZCIS were also increased in contrast with its counterparts. The merits of appropriate band alignment of TiO2, ZIS, and ZCIS and fewer interface defects built an internal electric field among the ternary hetero-junction, leading to an enhanced conductivity and efficient interface charge separation. These results were supported by a series of photo-electrochemical measurements. Among others, the shortened average lifetime of photo-generated electron-hole pairs from 1.51 (TiO2) to 1.17 ns (TiO2/ZIS/ZCIS) according to time-resolved photoluminescence reveals that the charge carriers generated in TiO2 would have an additional decay pathway in the hetero-structure, which benefits for the charge separation. Our strategy could be extended to many low-efficiency semiconductors for the design and synthesis of effective photo-anodes in PEC water splitting.

Hexagonal phase/cubic phase homogeneous ZnIn2S4 n-n junction photoanode for efficient photoelectrochemical water splitting

Facile Construction TiO2/ZnIn2S4/Zn0.4Ca0.6In2S4 Ternary Hetero-Structure Photo-Anode with Enhanced Photo-Electrochemical Water-Splitting Performance

Optimized the Carrier Transport Path and Separation Efficiency of 2D/2D Heterojunction in Photoelectrochemical Water Splitting

Synthesis of a Cu2O/Carbon Film/NiCoB‐Grpahene Oxide Heterostructure As Photocathode for Photoelectrochemical Water Splitting

Construction of p-n junctions in single-unit-cell ZnIn<sub>2</sub>S<sub>4</sub> nanosheet arrays toward promoted photoelectrochemical performance

Complementary photoelectrochemical performances between dual heterojunctions and homojunction to achieve efficient solar water splitting of ZnIn 2 S 4 -based photoanode

Plasmon-induced hole-depletion layer on p-n heterojunction for highly efficient photoelectrochemical water splitting

Complementary Photoelectrochemical Performances Between Dual Heterojunctions and Homojunction to Achieve Efficient Solar Water Splitting of ZnIn2S4-based Photoanode

1D/0D WO3/CdS heterojunction photoanodes modified with dual co-catalysts for efficient photoelectrochemical water splitting

A ZnO/ZnFe2O4 Uniform Core-Shell Heterojunction with a Tubular Structure Modified by NiOOH for Efficient Photoelectrochemical Water Splitting.

3D Porous Pyramid Heterostructure Array Realizing Efficient Photo‐Electrochemical Performance

Sufficient Energy Band Utilization Profited from Spatially Discrete Heterogeneous Interfaces to Induce Efficient Photoelectrochemical Water Splitting for ZnIn2S4 Photoanode

Engineering Interfacial Band Bending over ZnIn<sub>2</sub>S<sub>4</sub>/SnS<sub>2</sub> by Interface Chemical Bond for Efficient Solar‐Driven Photoelectrochemical Water Splitting

Enhanced photoelectrochemistry water splitting based on the bi-piezoelectric Z-scheme pn heterojunction of an n-CdTe/p-ZnO nanorods array

Engineering Interfacial Band Bending over ZnIn<sub>2</sub>S<sub>4</sub>/SnS<sub>2</sub> by Interface Chemical Bond for Efficient Solar-Driven Photoelectrochemical Water Splitting

Synthesis of CuI/Sn-ZnO Based p-n Heterojunction Photoanode for Photoelectrochemical Water Splitting

Construction Homojunction and Co-Catalyst in ZnIn2S4 Photoelectrode by Co Ion Doping for Efficient Photoelectrochemical Water Splitting

Fabrication of in 2 O 3 /zno Hetero-Epitaxial-junctions with Enhanced PEC Performances

ZnO photoelectrode simultaneously modified with Cu2O and Co-Pi based on broader light absorption and efficiently photogenerated carrier separation

ZnO/In 2 S 3 /Co–Pi ternary composite photoanodes for enhanced photoelectrochemical properties

Epitaxial In2S3/ZnIn2S4 Heterojunction Nanosheet Arrays on FTO Substrates for Photoelectrochemical Water Splitting