Abstract:Surfactants are widely used in many industrial processes, where the presence of surfactants not only reduces the interfacial tension between fluids but also alters the wetting properties of solid surfaces. To understand how the surfactants influence the droplet motion on a solid surface, a hybrid method for interfacial flows with insoluble surfactants and contact-line dynamics is developed. This method solves immiscible two-phase flows through a lattice Boltzmann color-gradient model and simultaneously solves the convection-diffusion equation for surfactant concentration through a finite difference method. In addition, a dynamic contact angle formulation that describes the dependence of the local contact angle on the surfactant concentration is derived, and the resulting contact angle is enforced by a geometrical wetting condition. Our method is first used to simulate static contact angles for a droplet resting on a solid surface, and the results show that the presence of surfactants can significantly modify surface wettability, especially when the surface is more hydrophilic or more hydrophobic. This is then applied to simulate a surfactant-laden droplet moving on a substrate subject to a linear shear flow for varying effective capillary number ( Cae), Reynolds number ( Re), and surface wettability, where the results are often compared with those of a clean droplet. For varying Cae, the simulations are conducted by considering a neutral surface. At low values of Cae, the droplet eventually reaches a steady deformation and moves at a constant velocity. In either a clean or surfactant-laden case, the moving velocity of the droplet linearly increases with the moving wall velocity, but the slope is always higher (i.e., the droplet moves faster) in the surfactant-laden case where the droplet exhibits a bigger deformation. When Cae is increased beyond a critical value ( Cae,c), the droplet breakup would happen. The presence of surfactants is found to decrease the value of Cae,c, but it shows a non-monotonic effect on the droplet breakup. An increase in Re is able to increase not only droplet deformation but also surfactant dilution. The role of surfactants in the droplet behavior is found to greatly depend upon the surface wettability. For a hydrophilic surface, the presence of surfactants can decrease the wetting length and enables the droplet to reach a steady state faster; while for a hydrophobic surface, it increases the wetting length and delays the departure of the droplet from the solid surface.

Data on the Critical Condition of Silica and Ice Particles Removal from Surface.

New Model for Particle Removal from Surface in Presence of Deformed Liquid Bridge

The Water-Amorphous Silica Interface: Analysis Of The Stern Layer And Surface Conduction

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

Effects of Surface Roughness on Splashing Characteristics of Large Droplets with Digital Inline Holographic Imaging

A Front-Tracking Method for Simulating Interfacial Flows with Particles and Soluble Surfactants

Morphological Characteristics of Gas-Liquid Interfaces Receding Through the Mesoscopic Gap with a Sharp Feature

Atomistic understanding of interfacial processing mechanism of silicon in water environment: A ReaxFF molecular dynamics simulation

Study on the Ice Friction Characteristics

Numerical Study of Droplet Dynamics on a Solid Surface with Insoluble Surfactants.

Ablation and Molten Layer Flow Simulation for Plate Model of SiO 2f /SiO 2 Composite Material Using Particle Method

In situ investigation of ice formation on surfaces with representative wettability

Effect of Particle Impact on Surface Cleaning Using Dry Ice Jet

Probing Boundary Conditions at Hydrophobic Solid-Water Interfaces by Dynamic Film Drainage Measurement

Numerical Simulation of Ice Crystal Supercooled Droplet Mixed Phase Icing Based on the Improved Messinger Model

Wetting Behaviours of a Single Droplet on Biomimetic Micro Structured Surfaces

Unraveling Ice-Solid Interface Rupture Dynamics: Insights from Molecular Dynamics Simulations

Quasi-Brittle Ice Breaking Mechanisms by High-Velocity Water Jet Impacts: an Investigation Based on Pd-Sph Coupling Model and Experiments

3-D computational study of a single droplet impacting the random rough surface: Hydromechanical solidification

Ice model crevice effect on vertical water-entry of a sphere

Friction of Droplets Sliding on Microstructured Superhydrophobic Surfaces.