Abstract:Wireless Power Transfer (WPT) brings convenience and safety in many applications and serves as a research hot spot in recently years. Magnetic resonant coupling is widely implemented in WPT applications such as mobile devices and electric vehicles where large distance, large power amount and high efficiency are the three key requirements in real application. However, there are always trade-offs between these requirements even in theory. Former literatures failed to illustrate the complete relationships between these requirements. Based on the phasor analysis, this paper illustrates the operating principle of the whole circuit, attains the equivalent circuit models of the system and derives the physical essence of frequency characteristics. Then Maximum Efficiency Conditions (MEC), which achieves the maximum efficiency without sacrificing the requirements for power transfer distance and power amount, is summarized. It should be noted that the highest efficiency is achieved at the natural frequency of the receiver, instead of any split frequencies of the coupled resonances. Following the MEC, a WPT prototype was designed, which was composed of a full bridge inverter, a LC resonant transmitter, a LC resonant receiver and a full bridge rectifier. The resonant frequency of the transmitter was designed to be slightly lower than the inverter operation frequency-446kHz to make an inductive load for the inverter so that all the MOSFETs operated in Zero-Voltage-Switching (ZVS) condition. For the experimental results, 300 W output power was obtained over a distance of 22cm with 84% overall efficiency.

Design of a Constant-voltage Output Wireless Power Transfer Device

Design and Optimization of a Wireless Power Transfer System with a High Voltage Transfer Ratio

Design of a Wireless Energy Transfer System with Constant Ouput

A Constant Current Wireless Power Transfer Scheme with Asymmetric Loosely Coupled Transformer for Electric Forklift

A Heterogeneous Inductive Power Transfer System for Electric Vehicles with Spontaneous Constant Current and Constant Voltage Output Features

An Asymmetrical Loosely Coupled Transformer and Constant Current Wireless Charging Scheme for Warehouse Vehicles

Inductive Wireless Power Transmission Device Design for High-Voltage Systems

Constant-Current and Constant-Voltage Output Using Hybrid Compensated Single-Stage Resonant Converter for Wireless-Power-Transfer

Design of a highly integrated wireless power transfer system

Design for Constant Output Voltage and Current Controllability of Primary Side Controlled Wireless Power Transfer System

Analysis and Design of a Wireless Power Transfer System Based on Interleaved Boost Converter

Design of Wireless Power Transfer System Based on LCC-S

Constant output voltage and non-communication-based maximum efficiency tracking for wireless power transfer systems: Single current control of primary-side

Modeling and Analysis of Wireless Power Transfer System with Constant-Voltage Source and Constant-Current Load

Design of Wireless Power Transfer System for Low-Speed Vehicles Based on LCC-S Topology

Research on Constant Voltage/Current Output of LCC–S Envelope Modulation Wireless Power Transfer System

Study on Efficiency Maximization Design Principles for Wireless Power Transfer System Using Magnetic Resonant Coupling

Multi-coil Constant Voltage Output Analysis Based on State Deconstruction for Wireless Power Transfer System

Analysis and Design of Multiple Regulatable Output Rectifier-Integrated Buck Converter for Wireless Power Transfer Application

Wireless Power Transfer for Battery Powering System

Analysis and Design of a Cost-Effective Single-Input and Regulatable Multioutput WPT System