Microstructure and Compressive Behavior of Lamellar Al2O3p/Al Composite Prepared by Freeze-Drying and Mechanical-Pressure Infiltration Method

Qiang Zhang,Shanliang Dong,Shuai Ma,Xuwei Hou,Wenshu Yang,Yumin Zhang,Gaohui Wu

DOI: https://doi.org/10.1515/secm-2020-0001

IF: 1.901

2020-01-01

Science and Engineering of Composite Materials

Abstract:Infiltrated molten Al matrix by mechanical-pressure infiltration method into the ceramic scaffold prepared by freeze-drying technology could prepare dense lamellar Al matrix composites without damage of the biomimetic microstructure of the scaffold. However, the investigation of lamellar Al matrix composites prepared by freeze-drying and mechanical-pressure infiltration method has not been fully understood yet. In the present work, the Al2O3 scaffold with pearl layer structure was prepared by freezing-dry method, and eventually the lamellar Al(2)O(3)p/Al composite was fabricated by mechanical-pressure infiltration method. The Al matrix was infiltrated well into the large pores of the Al2O3 scaffold, and the lamellar structure of the Al2O3 was well preserved. The hardness of the lamellar Al(2)O(3)p/Al composite was isotropic in transvers and perpendicular directions. However, the compressive strengths of the lamellar Al(2)O(3)p/Al composite were significant anisotropic while the compressive strength in transvers direction was 127.7% higher than that in the perpendicular direction, indicating the integrality of the lamellae microstructure (especially the bridging layers). Due to the mismatched deformability, weak debonding was observed between Al and Al(2)O(3)p/Al layers in the fracture surface of the lamellar Al(2)O(3)p/Al composite. It indicates that the interfacial bonding between Al and Al(2)O(3)p/Al layers is rather strong, which is beneficial for higher strength in transvers direction but lead to lower strength in perpendicular direction.