Abstract:The focus of this paper is on multi-user MIMO transmissions for millimeter wave systems with a hybrid precoding architecture at the base-station. To enable multi-user transmissions, the base-station uses a cell-specific codebook of beamforming vectors over an initial beam alignment phase. Each user uses a user-specific codebook of beamforming vectors to learn the top-P (where P >= 1) beam pairs in terms of the observed SNR in a single-user setting. The top-P beam indices along with their SNRs are fed back from each user and the base-station leverages this information to generate beam weights for simultaneous transmissions. A typical method to generate the beam weights is to use only the best beam for each user and either steer energy along this beam, or to utilize this information to reduce multi-user interference. The other beams are used as fall back options to address blockage or mobility. Such an approach completely discards information learned about the channel condition(s) even though each user feeds back this information. With this background, this work develops an advanced directional precoding structure for simultaneous transmissions at the cost of an additional marginal feedback overhead. This construction relies on three main innovations: 1) Additional feedback to allow the base-station to reconstruct a rank-P approximation of the channel matrix between it and each user, 2) A zeroforcing structure that leverages this information to combat multi-user interference by remaining agnostic of the receiver beam knowledge in the precoder design, and 3) A hybrid precoding architecture that allows both amplitude and phase control at low-complexity and cost to allow the implementation of the zeroforcing structure. Numerical studies show that the proposed scheme results in a significant sum rate performance improvement over naive schemes even with a coarse initial beam alignment codebook.

UCA-Based Sub-Connected Hybrid Precoding for MmWave Multi-User Systems

Low-Complexity Two-Timescale Hybrid Precoding for Mmwave Massive MIMO: A Group-and-Codebook Based Approach

Mixed-Timescale Per-Group Hybrid Precoding for Multiuser Massive MIMO Systems.

Multi-User Hybrid Precoding for Dynamic Subarrays in MmWave Massive MIMO Systems

Codebook Based Hybrid Precoding for Millimeter Wave Multiuser Systems

Sub-Array Based Hybrid Precoding Design For Downlink Millimeter-Wave Multi-User Massive Mimo Systems

Hybrid Precoding for Multi-User Mmwave Systems Based on MMSE Criterion.

A Low-Complexity Hybrid Precoding Scheme for Mmwave MIMO Systems with Dynamic Subarrays

Machine Learning Based Hybrid Precoding for MmWave MIMO-OFDM with Dynamic Subarray

Energy-Efficient Multi-Antenna Hybrid Block Diagonalization Precoding and Combining for MmWave Massive Multi-User MIMO Systems

Limited Feedback Hybrid Precoding for Multi-User Millimeter Wave Systems

Joint User Scheduling and Hybrid Precoding for Multi-User Mmwave Systems with Two-Layer PS Network.

Hybrid Precoding for Millimeter Wave Communications with Fully Connected Subarrays

Hardware-Efficient Hybrid Precoding for Millimeter Wave Systems with Multi-Feed Reflectarrays

Robust Efficient Hybrid Pre-Coding Scheme for Mmwave Cell-Free and User-Centric Massive MIMO Communications

A Partially Dynamic Subarrays Structure for Wideband mmWave MIMO Systems

Enhanced Beam Selection for Multi-User Mm-Wave Massive Mimo Systems

Channel Reconstruction-Based Hybrid Precoding for Millimeter Wave Multi-User MIMO Systems

Hybrid Precoding with Per-Beam Timing Advance for Asynchronous Cell-free mmWave Massive MIMO-OFDM Systems

Two-stage BFGS-based Hybrid Precoding for Mmwave Multiuser MIMO Systems

DFT Codebook-Based Hybrid Precoding for Multiuser Mmwave Massive MIMO Systems